Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 187-2718 | Filter Wrench | 1 |
Start By:
- Release the system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Open the rear access door and turn the battery disconnect switch to the OFF position.
- Drain the hydraulic oil from the hydraulic oil tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.
- Open the engine access door on the right side of the machine.
Show/hide table
Illustration 1 g03743695 - Remove the nut, the washer, and wire assembly (3).
- Loosen the clamp and remove hose (2) from the back side of filter base (1).
- Disconnect hose assemblies (4) and (5) from filter base (1).
- Use Tool (A) in order to remove filter (6). Remove filter (6) from filter base (1).
- Remove the four bolts, the four washers, and filter base (1).
- Install filter base (1) in the reverse order of removal.
- Install filter (6). Refer to Operation and Maintenance Manual, "Hydraulic System Oil Filter - Replace".