PRODUCT SUPPORT PROGRAM FOR REPLACING THE ELECTRONIC MODULAR CONTROL PANEL (EMCP 4.2) ON CERTAIN PM3512 POWER MODULES
Usage:
TEBE5828-00
Show/hide table
| 14Mar2017 |
R15D
Show/hide table
| Before/After (Limited distribution) | PRODUCT SUPPORT PROGRAM FOR REPLACING THE ELECTRONIC MODULAR CONTROL PANEL (EMCP 4.2) ON CERTAIN PM3512 POWER MODULES |
|
| 7451 4490 | PS45415 |
|
Show/hide table
| NOTE: | Caterpillar’s obligations under this Service Letter are subject to, and shall not apply in contravention of, the laws, rules, regulations, directives, ordinances, orders, or statutes of the United States, or of any other applicable jurisdiction, without recourse or liability with respect to Caterpillar. |
| NOTE: | This Program must be administered either before or after failure. In either case the decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS45415" as the Part Number and "7755" as the Group Number. If administered before failure, use "56" as the Warranty Claim Description Code and "T" as the SIMS Description code. If administered after failure, use "96" as the Warranty Claim Description Code, and "Z" as the SIMS Description Code. |
Show/hide table
| NOTE: | The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst. |
Show/hide table
Show/hide table
Show/hide table
Show/hide table
TERMINATION DATE |
| 31Mar2019 |
PROBLEM
Show/hide table
| The EMCP overlay buttons may fail to operate on certain PM3512 power modules. The failure results in operators being unable to navigate through the controller overview and configuration menus or non operation of the Run, Stop and Auto buttons. This failure mode is not to be confused with a software reset issue while in Reduced Power Mode referenced in Engine News SEBD9946. |
AFFECTED PRODUCT
Show/hide table
| Model | Identification Number |
| PM3512 | TC800100-00102, 104, 106-114, 116-121, 124-148, 163-164, 166-167, 170, 172, 174, 178, 187, 191-200, 204-206, 215-216 |
PARTS NEEDED
Show/hide table
Qty |
Part Number | Description |
| 1 | 4509606 | CONT GP-A6001 |
| In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 18% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer. |
||
ACTION REQUIRED
Show/hide table
| If a confirmed Navigation, Run, Start or Stop button failure occurs, replace the EMCP. |
Show/hide table
SERVICE CLAIM ALLOWANCES
Show/hide table
0-24 mo |
||||||
Show/hide table
| NOTE: This is a 1.5-hour job | ||||||
Show/hide table
PARTS DISPOSITION
Show/hide table
| Handle the parts in accordance with your Warranty Bulletin on warranty parts handling. |
Caterpillar Information System:
PRODUCT SUPPORT PROGRAM FOR REPLACING THE OIL COOLER ON CERTAIN C175-16 LOCOMOTIVE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE OIL COOLER ON CERTAIN C175-16 LOCOMOTIVE ENGINES
PRODUCT SUPPORT PROGRAM FOR RECTIFYING PRELUBE RELAY FAILURES ON CERTAIN SOLUTIONS 3512B AND 3516B GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR RECTIFYING PRELUBE RELAY FAILURES ON CERTAIN SOLUTIONS 3512B AND 3516B GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE FUEL METERING VALVE INLET TUBE ON CERTAIN G3520H GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE FUEL METERING VALVE INLET TUBE ON CERTAIN G3520H GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE TURBOCHARGER STUD ON CERTAIN C32 MARINE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE TURBOCHARGER STUD ON CERTAIN C32 MARINE ENGINES
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE AIR BONNET GASKETS AND POSSIBLY REPLACING THE AFTERCOOLER CORE ON CERTAIN G3516H AND G3520H GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE AIR BONNET GASKETS AND POSSIBLY REPLACING THE AFTERCOOLER CORE ON CERTAIN G3516H AND G3520H GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR MODIFYING THE FLYWHEEL HOUSING AND INSTALLING A PAPER BEADED GASKET ON CERTAIN 3512C HD LOCOMOTIVE ENGINES, AT PLANNED COMPONENT REBUILD PRODUCT SUPPORT PROGRAM FOR MODIFYING THE FLYWHEEL HOUSING AND INSTALLING A PAPER BEADED GASKET ON CERTAIN 3512C HD LOCOMOTIVE ENGINES, AT PLANNED COMPONENT REBUILD
PRODUCT SUPPORT PROGRAM FOR INSPECTING/REPLACING THE AFTERCOOLER ON CERTAIN G3516H AND G3520H GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR INSPECTING/REPLACING THE AFTERCOOLER ON CERTAIN G3516H AND G3520H GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING A LARGER DRIP COVER ON CERTAIN G3520H GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING A LARGER DRIP COVER ON CERTAIN G3520H GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR REWIRING CONTROL PANEL RELAYS ON CERTAIN C13 GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REWIRING CONTROL PANEL RELAYS ON CERTAIN C13 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE VALVE LIFTERS AND GUIDE SPRINGS CERTAIN C9 MARINE GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REWORKING THE VALVE LIFTERS AND GUIDE SPRINGS CERTAIN C9 MARINE GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR RETESTING THE GENERATOR SET THAT WAS NOT TESTED TO THE CORRECT POWER FACTOR ON CERTAIN C4.4 GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR RETESTING THE GENERATOR SET THAT WAS NOT TESTED TO THE CORRECT POWER FACTOR ON CERTAIN C4.4 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE EXHAUST SYSTEM ON CERTAIN 3512C HD AND 3516C HD MARINE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE EXHAUST SYSTEM ON CERTAIN 3512C HD AND 3516C HD MARINE ENGINES
PRODUCT SUPPORT PROGRAM FOR REPLACING THE HIGH PRESSURE TURBOCHARGER WASTEGATE ACTUATOR ON CERTAIN 329F, AND 330F EXCAVATORS, 525D, 535D, 545D, AND 555D WHEEL SKIDDERS, 558B FOREST MACHINES, 563D, AND 573D WHEEL FELLER BUNCHERS, 815K SOIL COMPACTORS, PRODUCT SUPPORT PROGRAM FOR REPLACING THE HIGH PRESSURE TURBOCHARGER WASTEGATE ACTUATOR ON CERTAIN 329F, AND 330F EXCAVATORS, 525D, 535D, 545D, AND 555D WHEEL SKIDDERS, 558B FOREST MACHINES, 563D, AND 573D WHEEL FELLER BUNCHERS, 815K SOIL COMPACTORS,
PRODUCT SUPPORT PROGRAM FOR INSTALLING PRODUCT LINK ON CERTAIN XQ35 RENTAL GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR INSTALLING PRODUCT LINK ON CERTAIN XQ35 RENTAL GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING OR REWORKING THE BASE ON CERTAIN G3520H GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING OR REWORKING THE BASE ON CERTAIN G3520H GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR UPDATING THE FIRMWARE ON THE PRODUCT LINK MODULES ON CERTAIN PETEROLEUM PRODUCTS PRODUCT SUPPORT PROGRAM FOR UPDATING THE FIRMWARE ON THE PRODUCT LINK MODULES ON CERTAIN PETEROLEUM PRODUCTS
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE PRELUBE PUMP RELAY ON CERTAIN CG170-16, G3516H, AND G3520H GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE PRELUBE PUMP RELAY ON CERTAIN CG170-16, G3516H, AND G3520H GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE GENERATOR ON CERTAIN C4.4 MARINE GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REPLACING THE GENERATOR ON CERTAIN C4.4 MARINE GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING CELLULAR PRODUCT LINK DEVICES ON CERTAIN CATERPILLAR PRODUCTS PRODUCT SUPPORT PROGRAM FOR REPLACING CELLULAR PRODUCT LINK DEVICES ON CERTAIN CATERPILLAR PRODUCTS
PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE JACKET WATER PRESSURE SENSORS ON CERTAIN CG170-16, G3516H, AND G3520H GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE JACKET WATER PRESSURE SENSORS ON CERTAIN CG170-16, G3516H, AND G3520H GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE JACKET WATER HEATER PUMP ON CERTAIN 3512C HD LOCOMOTIVE ENGINES PRODUCT SUPPORT PROGRAM FOR REWORKING THE JACKET WATER HEATER PUMP ON CERTAIN 3512C HD LOCOMOTIVE ENGINES
PRODUCT SUPPORT PROGRAM FOR REPLACING THE CAMSHAFT COVER GASKET ON CERTAIN CG170-16, G3516H, AND G3520H GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REPLACING THE CAMSHAFT COVER GASKET ON CERTAIN CG170-16, G3516H, AND G3520H GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE LOW PRESSURE FUEL LINES ON CERTAIN C175-20 LOCOMOTIVE ENGINES PRODUCT SUPPORT PROGRAM FOR REWORKING THE LOW PRESSURE FUEL LINES ON CERTAIN C175-20 LOCOMOTIVE ENGINES
PRODUCT SUPPORT PROGRAM FOR INSTALLING PRODUCT LINK PLE601 ON CERTAIN C175 GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR INSTALLING PRODUCT LINK PLE601 ON CERTAIN C175 GENERATOR SETS