- A/C Compressor
- Condenser coil
- Receiver-dryer
- Expansion valve
- Evaporator core
- HVAC evaporator thermostat switch
- Accumulator
- HVAC water valve continuous signal (electronic rotational actuator)
- Heater coil
- A/C high/low pressure switch
- A/C low-pressure switch
- Cabin Air filter
- Louver temperature sensor
- HVAC operator cab controls
Illustration 1 | g03577698 |
The A/C compressor is located on the right-hand side of the engine underneath the alternator.
Illustration 2 | g03577697 |
The receiver dryer is located under the A/C service shroud on the right side of the machine next to the cab.
Illustration 3 | g03577716 |
The HVAC expansion valve is located in the coolant line behind the receiver/dryer.
Illustration 4 | g03577718 |
The HVAC low-pressure switch is located in the A/C line near the compressor.
Illustration 5 | g03577719 |
The HVAC low-pressure switch is located in the A/C line near the compressor.
Illustration 6 | g03577720 |
The evaporator coil is located inside the exchange box under the A/C shroud on the right-hand side of the machine next to the cab.
HVAC Water Valve Continuous Signal (Electronic Rotational Actuator)
Illustration 7 | g03577721 |
Illustration 8 | g03577722 |
The heater coil is located next to the evaporator coil in the exchange box next to the cab on the right-hand side of the machine.
Illustration 9 | g03398542 |
The evaporator thermostat is located on top of the exchange box and between the evaporator coil and the heater coil.
Illustration 10 | g03398543 |
The louver temperature sensor is located in the duct work on the lower right-hand side of the cab.
Illustration 11 | g03398559 |
The HVAC blower motor is located on the right-hand side of the cab.
Illustration 12 | g03398561 |
The HVAC operator cab controls are located on the right hand upper corner of the cab.