2010/12/02 Caterpillar


A New Torque Is Now Used for Tightening the Plug Assembly for Front Gear Group on Certain Motor Graders {4053}

Usage:

140M B9D
Motor Grader:
120M (S/N: PJB1-UP; B9W1-UP; D9W1-UP)
140MSeries II (S/N: M9J1-UP)
140M (S/N: B9D1-UP; B9G1-UP; D9G1-UP; B9M1-UP)
160MSeries II (S/N: M9K1-UP)
160M (S/N: B9E1-UP; B9L1-UP; B9T1-UP; D9T1-UP)
Service Magazine, SEPD1212, 2 December 2010, "A New Torque Is Now Used for Tightening the Plug Assembly for Front Gear Group on Certain Motor Graders". Disregard this article. See the replacement article that follows.

Description of Change: The new torque will eliminate the oil leakage through the plug assembly and increases the service life of the front gear group.

Adaptable To:




Illustration 1g02330716

Typical example

The 295-2582 Plug As is part of 292-3483 Front Gear Gp (ALL WHEEL DRIVE, LH) and 292-3482 Front Gear Gp (ALL WHEEL DRIVE, RH).

(1) Torque for the 295-2582 Plug As ... 30 ± 10 N·m (266 ± 89 lb in) The new torque value for the plug assembly is adaptable to and effective in production with the machines that are listed in Table1.

Table 1
Adaptable to the Machines     Effective with the Machines    
S/N:B9W1-208     S/N:B9W209-UP    
S/N:D9W1-191     S/N:D9W192-UP    
S/N:PJB1-154     S/N:PJB155-UP    
S/N:B9D1-2726     S/N:B9D2727-UP    
S/N:B9G1-1056     S/N:B9G1057-UP    
S/N:B9M1-1047     S/N:B9M1048-UP    
S/N:D9G1-1139     S/N:D9G1140-UP    
S/N:M9J1-204     S/N:M9J205-UP    
S/N:B9E1-457     S/N:B9E458-UP    
S/N:B9L1-491     S/N:B9L492-UP    
S/N:B9T1-176     S/N:B9T177-UP    
S/N:D9T1-160     S/N:D9T161-UP    
S/N:M9K1-202     S/N:M9K203-UP    

Caterpillar Information System:

120M Series 2, 120M2, 12M Series 2, 12M Series II, 140M Series 2 and 160M Series 2 Motor Graders Implement Electronic Control System MID 082 - CID 2223 - FMI 13
C9.3 Engines for Caterpillar Built Machines Air Control Valve - Remove and Install - Control Module, Clean Emissions Module
2010/11/08 A New Procedure is Used to Align The Air Conditioner Compressor Pulley on 793F, 795F and 797F Off-Highway Trucks {1802}
Realignment of The Air Conditioner Compressor Pulley on 793F, 795F and 797F Off-Highway Trucks{1802} Realignment of The Air Conditioner Compressor Pulley on 793F, 795F and 797F Off-Highway Trucks{1802}
992K Wheel Loader Electrohydraulic System Pressure Sensor (Lift Cylinder Head End Oil)
Installing the 350-9038 Air Conditioner and Heater Installation Kit (Conversion){1802, 1805, 1808, 7174, 7304, 7320, 734D} Installing the 350-9038 Air Conditioner and Heater Installation Kit (Conversion){1802, 1805, 1808, 7174, 7304, 7320, 734D}
770G and 772G Off-Highway Truck Capacities (Refill)
Transmission, Torque Converter, and Final Drive Updates for 768C through 793C Off-Highway Trucks{3001, 3030, 4050} Transmission, Torque Converter, and Final Drive Updates for 768C through 793C Off-Highway Trucks{3001, 3030, 4050}
Reusability of Rear Final Drive Splines on 769 to 784 Off-Highway Trucks{3259, 4050, 4051} Reusability of Rear Final Drive Splines on 769 to 784 Off-Highway Trucks{3259, 4050, 4051}
Salvage and Reuse of Final Drive Axle Bearings Used in Off-Highway Trucks/ Tractors and 990 to 994 Wheel Loaders {4050, 4051} Salvage and Reuse of Final Drive Axle Bearings Used in Off-Highway Trucks/ Tractors and 990 to 994 Wheel Loaders {4050, 4051}
"White Layer Flaking" of Transfer Gears in Off-Highway Trucks and Tractors{3159} "White Layer Flaking" of Transfer Gears in Off-Highway Trucks and Tractors{3159}
770G and 772G Off-Highway Truck Engine Starting with Auxiliary Start Receptacle
120M Series 2, 120M2, 12M Series 2, 12M Series II, 140M Series 2 and 160M Series 2 Motor Graders Implement Electronic Control System MID 082 - CID 2224 - FMI 13
770G and 772G Off-Highway Truck Engine Exhaust (Diverter) - If Equipped
793F Series AC Off-Highway Truck/Tractor Power Train Electronic Control System General Information
2010/11/16 A New Oil Pan Gasket is Now Used on 793F Off-Highway Truck Engines {1302, 7555}
Procedure to Replace Software and Calibrate the Maximum Propel Speed for CD54 Vibratory Asphalt Compactor {5721, 5910, 7620} Procedure to Replace Software and Calibrate the Maximum Propel Speed for CD54 Vibratory Asphalt Compactor {5721, 5910, 7620}
2010/11/22 A Procedure to Replace Software and Calibrate the Maximum Propel Speed for CD54 Vibratory Asphalt Compactor is Now Available {5721, 5910, 7620}
793F Series AC Off-Highway Truck/Tractor Power Train Electronic Control System Electric Power Generation
793F Series AC Off-Highway Truck/Tractor Power Train Electronic Control System Electric Drive System
795F AC and 795F AC XQ Off-Highway Truck Engine Supplement Engine Oil Cooler - Remove
795F AC and 795F AC XQ Off-Highway Truck Engine Supplement Engine Oil Cooler - Install
C6.6 Industrial Engine Cooling System
777G Off-Highway Truck VIMSTM 3G and Payload MID 161 - CID 1273 - FMI 12
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.