Pump Efficiency (Gear Pumps) - Test
Show/hide table
热油和热的部件可能会导致人身伤害。 不要让热油或热的部件与皮肤接触。 |
Show/hide table
注意 |
---|
在进行检验、保养、测试、调整及维修产品期间,必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前,要准备好合适的容器收集液体。 有关收集和盛接 Cat 产品上油液的适用工具和用品,请参阅专门出版物, NENG2500, "代理商维修工具目录"。 按照当地法规和要求处置所有液体。 |
本测试旨在验证泵的工作性能是否在其设计参数范围内。
对于任何泵测试,如果泵在相同转速下运行,在压力为
同等转速下不同工作压力之间得出的流量差就是流量损失。
Show/hide table
图 1 | g01089423 |
Show/hide table
图 2 | g01623868 |
Show/hide table
工具 | 项目 | 零件号 | 说明 | 数量 |
---|---|---|---|---|
A | A1 | 8T-0859 | 压力表
(0 到 25000 kPa(0 到 3600 psi)) |
1 |
A2 | 6V-3989 | 接头 | 1 | |
A3 | 6V-4143 | 快速连接连接器 | 2 | |
A4 | 177-7860 | 软管组件
(3.0 m(10 ft)) |
1 | |
B | 198-4240 | 数字压力指示器总成 | ||
B1 | 198-4234 | 数字指示器 | 1 | |
B2 | 198-4238 | 压力传感器总成
(0 至 3440 kPa(0 至 5000 psi)) |
1 | |
B3 | 198-4236 | 适配器缆线组件 | 1 | |
D | 4C-9911 | 流量计总成 |
参考: 执行此项调整之前,请参考测试和调整, "故障诊断与排除时的机器准备事项"。
- 操作机器,直到液压油温介于
50° 至 60°C (120° 至 110°F) 之间。 - 关闭发动机。 在轮胎两侧放置停车垫块。
- 确保停车制动器已接合。
- 将工具 (D) 安装到机器上。
使用工具 (A) 或 (B) 监视压力水平。 当转速为 1000 rpm、压力为
Show/hide table
确定流量损失的方法 |
转速为 1000 rpm、压力为 |
− 转速为 1000 rpm、压力为 |
= 流量损失(L/min 或 US gpm) |
Show/hide table
在机器上确定流量损失百分比的方法 | |
流量损失(L/min 或 US gpm) | × 100 = 流量损失百分比 |
满载转速、压力为 |
如果流量损失的百分比超过 10%,说明泵的性能不足。
Caterpillar Information System:
416E Backhoe Loader Loader Bucket, Cylinder, and Linkage Bearings - Lubricate
416E Backhoe Loader Lift Cylinder Brace - Connect and Disconnect
2008/11/01 Policy on Testing of Fuel Injectors and Fuel Nozzles {1251}
2008/11/17 Policy on Testing of Fuel Injectors and Fuel Nozzles {1251}
797B Off-Highway Truck Mirror
416E Backhoe Loader Shipping the Machine
416E Backhoe Loader Leaving the Machine
12K, 140K, 140K Series 2 and 160K Motor Graders Hydraulic and Steering System Steering System
416E Backhoe Loader Stabilizer Control
416E Backhoe Loader Backup Alarm
2008/11/17 Policy on Testing of Fuel Injectors and Fuel Nozzles {1251}
416E Backhoe Loader Plate Locations and Film Locations
EquipmentManager Dealer Administrator Manual Active Fleet
R1700G Load Haul Dump Circuit Breakers - Reset
R2900G Load Haul Dump Circuit Breakers - Reset
2009/02/23 New Oil Pump {1151, 1162, 1206}
CB54, CB54 XW and CB64 Vibratory Compactor Propel System Brake Pump
793F and 797F Off-Highway Trucks Chassis Electronic Control System System Schematic
2008/12/01 Water Temperature Regulator {1355, 1380}
IT38H Integrated Toolcarrier and 938H Wheel Loader Alternator Air Vent Line and Screen - Clean
416E Backhoe Loader Alternate Exit
The Procedure for Servicing the Air Cleaner on Articulated Trucks{1051, 1054} The Procedure for Servicing the Air Cleaner on Articulated Trucks{1051, 1054}
2008/12/29 New Software Prevents the Discrepancy Between the Display on the Monitor and the Service Hour Meter Reading for Certain Excavators {7490, 7601, 7610, 7620}
2008/12/01 A New Bearing is Now Used on the Support for the Conveyor on Certain Cold Planers {7074}