Start By:
- Install the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
- Install the retaining cable. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
The space between the body and the frame becomes a zero clearance area when the body is lowered. Failure to install the retaining cable can result in injury or death to personnel working in this area. |
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Put identification marks on all hose assemblies, on all tube assemblies and on all wire harnesses for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss and this helps to prevent contaminants from entering the system.
- Drain the hydraulic tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Hoist, Torque Converter and Brake Tank Oil - Change".
Show/hide table
Illustration 1 g01626224 - Disconnect hose assembly (1).
Show/hide table
Illustration 2 g01626221 - Disconnect hose assembly (2) and hose assembly (3).
Show/hide table
Illustration 3 g01626226 - Remove bolts (4) in order to disconnect tube assembly (5).
Show/hide table
Illustration 4 g01626229 - Disconnect hose assembly (6).
Show/hide table
Illustration 5 g01626232 - Attach a suitable lifting device onto gear pump (7). The weight of gear pump (7) is approximately
45 kg (100 lb) .Show/hide tableIllustration 6 g01626233 - Remove bolts (8) in order to remove gear pump (7).