Usage:
1. Remove four bolts (1) securing two flanges on each end of the water pipe and remove water pipe (2).
2. Remove two bolts (3) securing the flange on the end of the oil pipe and remove oil pipe (4) from the oil filter housing.
3. Remove two bolts (5) securing the flange on the end of the oil pipe on other side and remove oil pipe (6) from the oil filter housing.
4. Remove four oil filters (7).
5. Remove two bolts (8) and remove oil drip pan (10). Remove four bolts (9) from the lower support.
6. Attach tooling A to the top of the oil filter housing and remove five bolts (11) from the top support. Weight of the oil filter housing is 69 kg (152 lb).
NOTE: Installation of the oil filter housing is accomplished in the exact reverse order from removal.
NOTE: Prior to installation, lubricate the seal on the ends of pipe (2), (4), (6) and the oil seals on each of the oil filters with clean oil to insure proper installation. Check the oil level, and replace any oil that has been lost during removal with clean oil. See the Maintenance Manual for correct fluid level.
Disassemble and Assemble Oil filter Housing
Start By:
a. remove oil filter housing
1. Remove sixteen bolts (1) upper bracket (2) and lower bracket (3) from the top of the oil filter housing. Weight of the oil filter housing is 25 kg (55 lb).
2. Remove twenty one bolts and nuts (4) and separate each of the four oil filter housing segments (5).
NOTE: Each of the four oil filter housing segments, when separated, is identical.
3. Remove gasket (6) from each of the four oil filter housing segments.
 |
Cover (8) has spring tension behind it. Loosen bolts (7) slowly until all of the spring tension has been released. |
 |
4. Remove two bolts (7) and one cover (8) from each of the four oil filter housing segments.
5. Remove spring (11) and valve (10) and gasket (9) from the oil filter housing.
| NOTICE |
|---|
It is important that valve (10), spring (11) and the oil filter housing be clean and in good working order. If for any reason an oil filter would become inoperative this valve would allow oil to continue to flow thus preventing engine damage. |
6. Remove twelve bolts and two adapters (13), one from each end of the oil filter housings, and remove gasket (12).
NOTE: Assembly of the oil filter housing is accomplished in the exact reverse order from disassembly.
NOTE: Clean surfaces completely and replace all gaskets. When assembling oil filter housing, tighten bolts (4) in a criss-cross fashion to prevent the gaskets from warping and possible oil leaks.
End By:
a. install oil filter housing