Removal Procedure
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
| NOTICE |
|---|
Keep all parts clean from contaminants. Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components. To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly. Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination. |
 |
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
 |
- Remove guard (1) .
 | |
| Illustration 1 | g01392214 |
- Remove panel (2) .
 | |
| Illustration 2 | g01392215 |
- Remove panel (3) .
 | |
| Illustration 3 | g01392216 |
- Remove panel (4) .
 | |
| Illustration 4 | g01392217 |
- Disconnect hose assemblies (5) and (6) .
 | |
| Illustration 5 | g01392218 |
- Remove clamps (7). Remove accumulator (8) .
 | |
| Illustration 6 | g01392219 |
Installation Procedure
- Position accumulator (8). Install clamps (7) .
| | |
| Illustration 7 | g01392219 |
- Connect hose assemblies (5) and (6) .
| | |
| Illustration 8 | g01392218 |
- Install panel (4) .
| | |
| Illustration 9 | g01392217 |
- Install panel (3) .
| | |
| Illustration 10 | g01392216 |
- Install panel (2) .
| | |
| Illustration 11 | g01392215 |
- Install guard (1) .
| | |
| Illustration 12 | g01392214 |