AccuGradeTM - Grade Control System (GPS/ATS/Sonic/Cross Slope) Caterpillar

Note: The contents of the "Setup Menu" dialog are site configurable. Depending on the "Operator Configuration" settings of your system and machine setting, the number of items in the "Setup Menu" may vary. Refer to your site manager if a specific option is not available.

The Display and Light Bar Brightness dialog sets the brightness of the Display and the light bars.

1. From the "Setup Menu-Configuration" dialog, press the up arrow or the down arrow until "Adjust Brightness" is highlighted.

Show/hide table



Illustration 1	g01123501

2. Press the "OK" key.

   The "Display and Light Bar Brightness" dialog appears. Refer to Illustration 1.

   The "Display brightness" dialog is shown by default.

3. In order to adjust the display brightness, press the "Display" soft key. The field changes to "Display brightness". In order to adjust the light bar brightness, press the "light bar" soft key.

   The "Display Brightness" dialog is shown by default.

   Do one of the following:

4. Press the up arrow or the down arrow in order to increase or decrease the brightness.

5. Press the "Set Maximum" in order to select the maximum brightness.

6. Press the "OK" key in order to save the settings and return to the "Setup Menu-Configuration" dialog. Press the "ESC" key and then the "OK" key in order to cancel the changes.

7. Press the "ESC" key in order to exit the "Setup Menu-Configuration" dialog. All changes take effect immediately.

Note: The display brightness may also be changed with out entering a menu. Press the "MENU" key and "+" key in order to increase the brightness. Press the "MENU" key and "-" key in order to decrease the brightness.