AccuGradeTM - Grade Control System (GPS/ATS/Sonic/Cross Slope) Caterpillar

If this feature is turned ON, the "Vertical Offset Increment" dialog is used in order to set the amount each press of the vertical offset switches increases or decreases the vertical offset.

Complete the following steps in order to modify the value for the "Vertical Offset Increment" dialog.

1. Press the "Menu" key until the "Setup Menu – Configuration" is highlighted.

2. Press "Setup Menu – Configuration".

   Press the up arrow or the down arrow until "Vertical Offset Switch Increment" is highlighted.

Show/hide table



Illustration 1	g01123580

3. Press the "OK" key.

   The dialog that is shown in Illustration 1 is shown.

   Complete one of the following steps:

   1. Press the arrow keys in order to enter the amount that each press of the vertical offset switches will increases or decreases the vertical offset.

   2. Press the "Default 0.010" soft key in order to set the system default. The system default is 0.010 m (0.05 ft).

4. Press the "OK" key in order to save the settings and return to the "Setup Menu-Configuration" dialog.

5. Press the "ESC" key in order to exit the "Plan View". The changes take effect immediately.