IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Machine Systems Caterpillar


Secondary Steering Valve - Install

Usage:

950H J5J

Installation Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
FT-1114  Vacuum Cap 
5P-0306 Vacuum Transducer 
6V-4142 Fitting 
5K-5068 Fitting 

Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.



    Illustration 1g01166555

  1. Position secondary steering control valve (4) and install bolts (5).

  2. Connect hose assemblies (2).

  3. Connect harness assembly (3).


    Illustration 2g01165944

  4. Remove Tooling (A) from the hydraulic tank.


    Illustration 3g01166554

  5. Install cover assemblies (1).

End By:

  1. Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".

Caterpillar Information System:

IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Machine Systems Secondary Steering Valve - Remove
725 and 730 Articulated Trucks Machine Systems Steering Cylinder - Remove and Install
Instructions for Converting Intermittent Saw to Hot Saw{5050, 6327, 7000} Instructions for Converting Intermittent Saw to Hot Saw{5050, 6327, 7000}
PS-150B and PS-200B Paving Compactors Fuel System Water Separator - Drain
587R Pipelayer Fairlead Sheave - Lubricate
PS-150B and PS-200B Paving Compactors Parking Brake Manual Release
AP-1055D and BG-2455D Asphalt Pavers Propel System Lever (Propel Control) and Electronic Sensor - Test
2005/07/11 A New Hopper Lift Cylinder is Now Used on the Asphalt Pavers {7562}
AP-1055D and BG-2455D Asphalt Pavers Propel System Hydraulic Schematic (Propel System)
583T Pipelayer Ether Starting Aid Cylinder - Replace
725 and 730 Articulated Trucks Machine Systems Brake Control Valve (Service) - Remove and Install
587R Pipelayer Engine Valve Lash - Check
785D OEM Off-Highway Truck Machine Systems Check Valve (Service Brake) - Remove and Install
793D Off-Highway Truck Engine Supplement Alternator - Remove and Install
793D Off-Highway Truck/Tractor Relay Valve (Brake) - Remove
793D Off-Highway Truck/Tractor Relay Valve (Brake) - Install
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Introduction
793D Off-Highway Truck Suction Screen (Rear Axle Lubrication) - Clean
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Location of Electrical Components
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Location of Hydraulic Components
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Conveyor System
C27 and C32 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
PS-150B and PS-200B Paving Compactors Daily Inspection
587R Pipelayer Hook and Wire Cable - Inspect
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.