IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Machine Systems Caterpillar

Removal Procedure

Start By:

1. Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".

Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.

Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.

Show/hide table

Illustration 1	g01165944

1. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
   Show/hide table

   Illustration 2	g01166554

2. Remove cover assemblies (1).
   Show/hide table

   Illustration 3	g01166555

3. Disconnect hose assemblies (2).

4. Disconnect harness assembly (3).

5. Remove bolts (5) and secondary steering control valve (4).