Fuel System Water Separator - Drain
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Open the engine compartment.
- The water separator is located in the engine compartment toward the right side of the machine.
- Loosen the drain valve on the water separator bowl. Allow the water and sediment to drain into a suitable container.
Show/hide table
 | |
| Illustration 1 | g00890460 |
- Tighten the drain valve.
- If the engine fails to start, change the fuel filter. If there is a power loss, change the fuel filter.
- Tighten the drain valve and close the engine compartment.
Caterpillar Information System:
587R Pipelayer Fairlead Sheave - Lubricate
PS-150B and PS-200B Paving Compactors Parking Brake Manual Release
AP-1055D and BG-2455D Asphalt Pavers Propel System Lever (Propel Control) and Electronic Sensor - Test
2005/07/11 A New Hopper Lift Cylinder is Now Used on the Asphalt Pavers {7562}
AP-1055D and BG-2455D Asphalt Pavers Propel System Hydraulic Schematic (Propel System)
583T Pipelayer Ether Starting Aid Cylinder - Replace
725 and 730 Articulated Trucks Machine Systems Brake Control Valve (Service) - Remove and Install
587R Pipelayer Engine Valve Lash - Check
TH220B, TH330B and TH340B Telehandlers Machine Systems Battery
2005/05/23 New Source for Shaft Seal in Piston Pump (Steering) {4306, 5070}
2005/05/23 Correction to Operation and Maintenance Manuals for the Paving Compactors {5653, 6605, 6606}
12M, 140M and 160M Motor Graders Braking and Hydraulic Fan System Introduction
Instructions for Converting Intermittent Saw to Hot Saw{5050, 6327, 7000} Instructions for Converting Intermittent Saw to Hot Saw{5050, 6327, 7000}
725 and 730 Articulated Trucks Machine Systems Steering Cylinder - Remove and Install
IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Machine Systems Secondary Steering Valve - Remove
IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Machine Systems Secondary Steering Valve - Install
785D OEM Off-Highway Truck Machine Systems Check Valve (Service Brake) - Remove and Install
793D Off-Highway Truck Engine Supplement Alternator - Remove and Install
793D Off-Highway Truck/Tractor Relay Valve (Brake) - Remove
793D Off-Highway Truck/Tractor Relay Valve (Brake) - Install
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Introduction
793D Off-Highway Truck Suction Screen (Rear Axle Lubrication) - Clean
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Location of Electrical Components
AP-1055D and BG-2455D Asphalt Pavers Conveyor Systems Location of Hydraulic Components