 | |
| Illustration 1 | g00941455 |
| Operator Mode Scroll Switch (1) - Push down on the top half of switch (1) in order to scroll through the operator modes in display window (2) . |
Operator Modes
 | |
| Illustration 2 | g00992020 |
Service Meter - In this mode, the six digit display window will show the total number of machine operating hours. It should be used to determine maintenance intervals. Indicator (3) will show that the display window is operating in the service meter mode.
If there is an active fault, SERV CODE is displayed in the upper right hand corner of the display window. If SERV CODE is displayed during normal operation, an existing problem should be addressed.
 | |
| Illustration 3 | g00992022 |
Odometer - In this mode, the display window will show the total distance that has been travelled by the machine. This measurement can be displayed in "MILES" or "KM" depending on the units of measure selected.
 | |
| Illustration 4 | g00992024 |
Digital Tachometer - In this mode, the engine rpm will be displayed in the display window.
 | |
| Illustration 5 | g00992023 |
Diagnostic Scrolling - In this mode, the display window will show the faults that have been detected by the Caterpillar Monitoring System. Faults cannot be cleared in this mode. Also, faults may not be placed on hold. The service code will only be displayed when the fault is active.