Radiator, Hydraulic Oil Cooler, Air Cooler, and Fuel Cooler - Separate
Separation Procedure
Start By:
- Remove the radiator, the hydraulic oil cooler, the air cooler and the fuel cooler. Refer to Disassembly and Assembly, "Radiator, Hydraulic Oil Cooler, Air Cooler, and Fuel Cooler - Remove".
- Remove bolts (1) and remove bracket (2) and fan guard (3) from the shroud.
Show/hide table
Illustration 1 | g00944587 |
- Loosen the hose clamp and disconnect hose (4) from the radiator.
- Loosen the hose clamp and disconnect hose (5) from the air cooler.
- Remove bolts (7) and remove fuel cooler (6) from hydraulic oil cooler (8) .
Show/hide table
Illustration 2 | g00944588 |
- Remove bolts (9). Remove bolts (10) and remove hydraulic oil cooler (8) from the radiator.
Show/hide table
Illustration 3 | g00944589 |
Show/hide table
Illustration 4 | g00944590 |
- Remove brackets (11) from the radiator.
Show/hide table
Illustration 5 | g00944592 |
- Remove bolt (13) and bracket (12) from the radiator and from the air cooler.
- Remove bolts (15) and remove shroud (14) .
Show/hide table
Illustration 6 | g00944593 |
- Remove drain valve (16) and the fitting from the radiator.
- Remove seal (19) from both ends of radiator (17) and air cooler (18) .
Show/hide table
Illustration 7 | g00944594 |
- Remove bolts (20 ) from both ends of radiator (17) and air cooler (18). Separate radiator (17) and air cooler (18) .
Caterpillar Information System:
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Radiator, Hydraulic Oil Cooler, Air Cooler, and Fuel Cooler - Install
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Radiator, Hydraulic Oil Cooler, Air Cooler, and Fuel Cooler - Connect
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Pump Drive - Remove and Install
Procedure for Replacing the Control Valve for the Suspension and Hoist Systems on the D40D Articulated Trucks{7214} Procedure for Replacing the Control Valve for the Suspension and Hoist Systems on the D40D Articulated Trucks{7214}
AP-1000D, AP-1055D, AP-655C, BG-2255C, BG-2455D and BG-260D Asphalt Pavers MID 039 - CID 0986 - FMI 02
R1600G Load Haul Dump Indicators
C15 Petroleum Generator Set Engines Electronic Unit Injector Wiring
797 Off-Highway Truck Steering System Steering Control Valve - Adjust
R1600G Load Haul Dump Gauges
R1600 Load Haul Dump Caterpillar Monitoring System
CB-534D, CB-534D XW and CB-564D Paving Compactors Machine Systems Introduction (Water Spray System)
R1600G Load Haul Dump Idle Timer Control (Engine Shutdown) - If Equipped
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Radiator, Hydraulic Oil Cooler, Air Cooler, and Fuel Cooler - Remove
R1600G Load Haul Dump Light Switches
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Suction Fan (Fan and Fan Motor) - Assemble
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Suction Fan (Fan and Fan Motor) - Disassemble
CP-563E, CS-563E, CP-573E, CS-573E and CS-583E Vibratory Compactors Engine Supplement Battery and Battery Cable - Separate and Connect
RM-350B Reclaimer/Mixer Power Train Service Brake - Remove
RM-350B Reclaimer/Mixer Power Train Service Brake - Install
R1600G Load Haul Dump Remote Control Switch - If Equipped
R1600G Load Haul Dump Lift Arm Positioner Switch
R1600 Load Haul Dump Operator Mode Scroll Switch
2002/12/23 Correction to Systems Operation Testing and Adjusting "Ride Control Accumulator - Test and Charge" {5077}
R1300G Load Haul Dump Braking System Pressure Reducing Valve (Parking Brake Oil)