R3000H Load Haul Dump Machine Systems Caterpillar

Installation Procedure

Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.

Show/hide table

Illustration 1	g01091155
View of the right side of the rear frame

1. Attach a suitable lifting device to secondary steering diverter valve (1). The weight of the secondary steering diverter valve (1) is approximately 44 kg (97 lb).

2. Position secondary steering diverter valve (1) and install three bolts (9), the washers, and the spacers.

3. Connect electrical harness (8).

4. Connect hose assemblies (7) and (10).
   Show/hide table

   Illustration 2	g01091154
   View of the right side of the rear frame

5. Connect hose assembly (5) to secondary steering diverter valve (1).

6. Install elbow (6). Tighten four hose clamps (4).
   Show/hide table

   Illustration 3	g01091153
   View from the articulated hitch area

7. Connect hose assembly (3) to secondary steering diverter valve (1).
   Show/hide table

   Illustration 4	g01091151

8. Connect hose assembly (1) to secondary steering diverter valve (1).

9. Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the capacity of the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the proper filling procedure.

End By:

1. Remove the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install.".