Electric Starting Motor
Show/hide table
图 1 | g01392303 |
Show/hide table
图 2 | g01392304 |
A-A 视图 |
从小齿轮端部看电动起动马达时,马达按以下方向旋转。 ... 顺时针
- 速度 ... 7643 ± 1683 rpm
- 电流吸收 ... 76.5 ± 14.5 安培
- 电压 ... 23V
- 电流吸收 ... 76.5 ± 14.5 安培
(B) 小齿轮与壳体之间的间隙 ...
(1) 接地端子螺母的最终安装扭矩 ...
(2) 接地端子螺母的最终安装扭矩 ...
注: 蓄电池端子螺母 (3)最多可使用三条电缆或导线端子。 两个电缆端子最大不低于 0 AWG。
(3) 蓄电池端子螺母的最终安装扭矩 ...
注: 开关端子必须用热收缩管绝缘。 不要使用模压端子。
(4) 开关端子螺母的最终安装扭矩 ...
(5) 马达端子螺母的最终安装扭矩 ...
(6) 马达机架端子螺母的最终安装扭矩 ...
电磁阀组件
20V 和
- 拉动绕组 ... 57 安培
- 保持绕组 ... 16 安培
- 最大额定电流 ... 850 安培
- 保持绕组 ... 16 安培
Caterpillar Information System:
325D and 329D Excavators and 325D Material Handler Machine System Specifications Relief Valve (Pilot) - Front Lines
C175 Generator Set Engines Piston Cooling Jets - Remove and Install
C7 and C9 On-highway Engines Engine Operation
C15 Engine Refill Capacities and Recommendations
G3500 A3 Engines Engine Monitoring System - Oxygen Feedback
C15 Engine Information Plate
C15 Engine Serial Number Plate
345C MHPU Mobile Hydraulic Power Unit Machine Systems Pilot Valve (Travel) - Assemble
C15 Engine Engine Description
C15 and C18 Engines for Caterpillar Built Machines Alternator Mounting
345C MHPU Mobile Hydraulic Power Unit Machine Systems Pilot Valve (Travel) - Disassemble
C175 Generator Set Engines Air Cleaner - Remove and Install
C1.5 and C2.2 Generator Set Engines Generator - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Manual Ball Valve (Counterweight Circuit) - Install
C13 and C15 On-Highway Engines Reference Material
G3500 A3 Engines System Configuration Parameters - Oxygen Feedback
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Solenoid Valve (Counterweight Circuit) - Install
C1.5 and C2.2 Generator Set Engines Generator - Install
Installation and Initial Start-Up Procedure for G3500 A3 Engines {1000} Installation and Initial Start-Up Procedure for G3500 A3 Engines {1000}
C15 Engine Electronics Grounding Stud - Inspect/Clean/Tighten
C15 Engine Engine Crankcase Breather - Clean
C15 Engine Maintenance Interval Schedule
C7.1 Engines for Caterpillar Built Machines Lubrication System
2005/10/03 Responsibilities for Emission Certified Engines {1000}