Rocker Shaft and Pushrod - Install
安装步骤
- 放置推杆 (4) 和摇臂轴组件 (3) 。
Show/hide table
图 1 | g01137519 |
- 安装螺栓 (2) 、螺柱和螺母 (1) 。
End By:
- 安装气门执行器。 请参考 解体和组装, "气门执行器(可变)- 安装"。
- 调整发动机气门间隙。 请参考 测试与调整, "气门间隙调整"。
Caterpillar Information System:
C11 and C13 Engines Rocker Shaft and Pushrod - Remove
C11 and C13 Engines Electronic Unit Injector - Install
C11 and C13 Engines Electronic Unit Injector - Remove
C11, C13 and C15 On-highway Engines 0283-07 Intake Valve Actuation Oil Pressure not responding (91)
2003/07/01 Quality of Remanufactured Camshafts {1210}
C7 On-highway Engine Electronic Control Module - Remove and Install
C7 On-highway Engine Cylinder Head - Install
C7 On-highway Engine Cylinder Head - Remove
C7 On-highway Engine Turbocharger - Install
C7 Engines for Combat and Tactical Vehicles Engine Oil Level Gauge - Calibrate
C7 On-highway Engine Turbocharger - Remove
C15 and C18 Petroleum Generator Sets Parallel Operation
C11 and C13 Engines Fuel Filter Base - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove
C11 and C13 Engines for Caterpillar Built Machines Fuel Transfer Pump - Install
C4.4 (Mech) Industrial Engine Electrical System
G3520C and G3520E Generator Set Engines Valve Cover - Remove and Install
2003/11/01 New Unit Injector Rocker Arm Is Now Used {1123}
2003/07/21 A New Oversized Oil Pump Idler Gear Shaft is Available for 3054, 3054B, 3056 and 3056E Engines {1234, 1304}
C7 On-highway Engines Turbocharger - Inspect
C11 and C13 Engines Water Pump - Remove
G3520C and G3520E Engines Engine Mount
C15 On-highway Engine Pump Drive - Assemble
C15 On-highway Engine Pump Drive - Disassemble