TL5 Series Field Cultivator Caterpillar

Use the following procedure to prepare the implement to be serviced:

1. Park the implement in a suitable location for performing maintenance.

2. Completely raise the implement.

3. Stop the engine and set the parking brake.

4. Make sure that the wheel transport lock valve and the wing transport lock valve is in the locked position.

5. Install the service locks on the hydraulic cylinders for raising the center section.

6. Install the service lock on the hydraulic cylinder for the floating hitch, if equipped.

Lubricate the following grease fittings after every 40 service hours or weekly for the following components:

• Tongue

• linkage for leveling

• Hinges for the wings

• Walking beam

• Wheel hub

• Gauge wheels

Show/hide table

Personal injury or death could result from sudden implement movement. Lower the implement to the ground. Set the parking brake and stop engine before servicing the implement.

Tongue

Illustration 1	g00837461

Grease fittings (1) for the pivot pins on the tongue.

Linkages for Leveling

Illustration 2	g00837482

Grease the fittings (2) for the adjusting screw in the linkage.

Hinges for the Wings

Illustration 3	g00837497

Grease fittings (3) for the hinges on each wing.

Bearings for the walking beam

Illustration 4	g00837523

Grease fittings (4) for each of the walking beam.

Wheel Hubs

Illustration 5	g00837604

Illustration 6	g00837609

Grease fittings (5) for each of the wheel hubs.

Gauge Wheels

Illustration 7	g00837615

Grease fittings (6) for each of the gauge wheels.

Ratchet Jacks

Illustration 8	g00837642

Grease fittings (7) for each of the ratchet.