Fuel System Filter - Replace
Show/hide table
| NOTICE |
|---|
Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts. |
- Open the hood. Refer to Operation and Maintenance Manual, "Hood Tilt" for the procedure.
- Remove the fuel filter.
Show/hide table
 | |
| Illustration 1 | g00620723 |
- Inspect the fuel filter for debris by cutting the fuel filter open.
Note: The fuel filter is a cartridge type filter. The filter cannot be reused.
Note: Dispose of used filters and used fluids according to local regulations.
- Clean the filter mounting base. Make sure that all of the old seal is removed.
- Lubricate the seal of the new filter with clean diesel fuel.
Show/hide table
 | |
| Illustration 2 | g00101634 |
- Install the new filter by hand. Additionally tighten the filter by 3/4 of a turn, after the gasket contacts the filter base.
Every new filter has four rotation index marks. Each mark indicates 1/4 turn. Use these rotation index marks as a guide for proper tightening.
- Prime the fuel system. Refer to Operation and Maintenance, "Fuel System Priming Pump - Operate".
- Close the hood.
Caterpillar Information System:
816F Landfill Compactor, 815F Soil Compactor and 814F Wheel Dozer Fan Drive Bearing - Lubricate
3176C and 3406E Engines for Caterpillar Built Machines System Configuration Parameters
3054 Engine Cooling System - Inspect
TK1051 Track Feller Buncher Ether Starting Aid Cylinder - Replace
Instructions for Installation of Turbine Precleaners on Products with Dust Ejectors {1055} Instructions for Installation of Turbine Precleaners on Products with Dust Ejectors {1055}
2001/05/21 The Rear Axle Housing Is Now Equipped with Extra Lugs and Extra Spacers for Custom Products {3260}
IT12F, IT14F, IT18F, IT24F and IT28F Integrated Toolcarriers and 910F, 918F, 924F and 928F Wheel Loaders Power Train Electronic Control System Solenoid Valves
IT12F, IT14F, IT18F, IT24F and IT28F Integrated Toolcarriers and 910F, 918F, 924F and 928F Wheel Loaders Power Train Electronic Control System Sensors
TK1051 Track Feller Buncher Machine System Relief Valve (Pilot)
TK1051 Track Feller Buncher Machine Systems Travel Motor
3054 Engine Valve Guide - Inspect
816F Landfill Compactor, 815F Soil Compactor and 814F Wheel Dozer Engine Oil and Filter - Change
3056 Engine for Caterpillar Built Machines Cooling System - Test
3054 Engine Cooling System - Check
IT12F, IT14F, IT18F, IT24F and IT28F Integrated Toolcarriers and 910F, 918F, 924F and 928F Wheel Loaders Power Train Electronic Control System Related Components
TK1051 Track Feller Buncher Fuses - Replace
2001/04/23 A New Flash File Is Used on the Electronic Control Module of Wheel Harvesters {7490, 7620}
735 Articulated Truck Power Train Differential - Test
TH103 Telehandler Hydraulic System Frame Leveling System
740 and 740 EJECTOR Articulated Trucks Power Train Torque Converter
TH103 Telehandler Hydraulic System Auxiliary System
735 Articulated Truck Power Train Torque Converter
533 and 543 Wheel Feller Bunchers Engine Stopping
740 and 740 EJECTOR Articulated Trucks Power Train Transmission Planetary