Fuel System Water Separator - Drain
Show/hide table
 |
Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
 |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
- Open the engine access door on the right hand side of the machine.
Show/hide table
 | |
| Illustration 1 | g00689411 |
- In order to open the drain valve, turn the valve in a counterclockwise direction. Allow the water to completely drain.
Show/hide table
 | |
| Illustration 2 | g00689432 |
- Drain the water and sediment into a suitable container.
Note: Dispose of the waste in a proper manner.
- Close the drain valve.
- Close the engine access door.
Caterpillar Information System:
CB-534C Vibratory Compactor Fuel System Primary Filter - Clean/Inspect/Replace
2000/03/20 A Special Instruction for Installing an Auxiliary Lines Kit is now Available {5051, 5057}
D400E Series II Ejector Truck Machine Operation
G3304 and G3306 Engines Engine Speed Measurement
D400E Series II Ejector Truck Crushing Prevention and Cutting Prevention
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Hydraulic System Saw Bar Cylinder Return Speed (Excavator) - Test and Adjust
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Hydraulic System Feed Roller Arm Cylinder Pressure (Excavator) - Test and Adjust - HH55, HH65, and HH75
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Connecting Rod - Inspect
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Hydraulic System Feed Roller Arm Cylinder Pressure (Excavator) - Test and Adjust - HH45 Only
CS-431C, CP-433C and CS-433C Vibratory Compactors Propel System Piston Motor (Axle Propel)
D400E Series II Ejector Truck Ejector, Steering, and Brake System Breather - Replace
2002/05/27 The Correct Position of the Clamp Assembly is Required in order to Prevent Damage to the Tie Rod Assembly {4318, 4329}
CB-534C Vibratory Compactor Fuel System Water Separator Element - Replace
793C Off-Highway Truck Traction Control System (TCS) - Test
793C Off-Highway Truck Throttle Backup Switch
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Speed Sensor - Replace
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Controller - Replace
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0295 FMI 02 Electronic Control Module (Machine) Incorrect Signal - Test
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Controller Input and Output Values
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0295 FMI 09 Electronic Control Module (Machine) Abnormal Update - Test
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0295 FMI 12 Electronic Control Module (Machine) Failed - Test
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Torque Converter Charging, Scavenge, and Brake Release)
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Torque Converter Charging, Scavenge, and Brake Release)
2000/03/27 Dimensions in Special Instruction are now Updated {3260, 3269, 6116, 6118, 6119, 6125, 6126, 6127, 7057, 7069, 7100}