CB-534C Vibratory Compactor Caterpillar


Fuel System Primary Filter - Clean/Inspect/Replace

Usage:

CB-534C 1WS



Illustration 1g00689251

  1. Turn drain valve (3) counterclockwise in order to open the valve.

  1. Drain water and sediment in a suitable container.

  1. Close drain valve (3) .

  1. Loosen filter collar (1) .

  1. Remove the filter (2). Discard filter (2) .

  1. Clean the inside surfaces of the filter head.

  1. Inspect the seal in the filter head. Replace the seal in the filter head if the seal is damaged or worn.

  1. Install a new filter element. Tighten collar (1) in order to secure the filter.

Note: Dispose of drained fluids and used filters according to local regulations.

Note: Do not start the engine until the fuel system has been completely serviced.

Caterpillar Information System:

2000/03/20 A Special Instruction for Installing an Auxiliary Lines Kit is now Available {5051, 5057}
D400E Series II Ejector Truck Machine Operation
G3304 and G3306 Engines Engine Speed Measurement
D400E Series II Ejector Truck Crushing Prevention and Cutting Prevention
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Hydraulic System Saw Bar Cylinder Return Speed (Excavator) - Test and Adjust
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Hydraulic System Feed Roller Arm Cylinder Pressure (Excavator) - Test and Adjust - HH55, HH65, and HH75
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Connecting Rod - Inspect
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Hydraulic System Feed Roller Arm Cylinder Pressure (Excavator) - Test and Adjust - HH45 Only
CS-431C, CP-433C and CS-433C Vibratory Compactors Propel System Piston Motor (Axle Propel)
D400E Series II Ejector Truck Ejector, Steering, and Brake System Breather - Replace
2002/05/27 The Correct Position of the Clamp Assembly is Required in order to Prevent Damage to the Tie Rod Assembly {4318, 4329}
D400E Series II Ejector Truck Ejector, Steering, and Brake System Tank Screen - Clean
CB-534C Vibratory Compactor Fuel System Water Separator - Drain
CB-534C Vibratory Compactor Fuel System Water Separator Element - Replace
793C Off-Highway Truck Traction Control System (TCS) - Test
793C Off-Highway Truck Throttle Backup Switch
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Speed Sensor - Replace
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Controller - Replace
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0295 FMI 02 Electronic Control Module (Machine) Incorrect Signal - Test
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Controller Input and Output Values
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0295 FMI 09 Electronic Control Module (Machine) Abnormal Update - Test
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) CID 0295 FMI 12 Electronic Control Module (Machine) Failed - Test
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Torque Converter Charging, Scavenge, and Brake Release)
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Torque Converter Charging, Scavenge, and Brake Release)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.