Illustration 1 | g00686134 |
Note: Before assembly, lubricate the components with clean engine oil.
(1) Tighten the bolts for the brackets of the rocker shaft to the following torque. ... 9 N·m (80 lb in)
(2) Three plates with threaded studs
The three studs are for mounting the valve mechanism cover.
(3) Tighten the nuts for the brackets of the rocker shaft to the following torque. ... 22 N·m (16 lb ft)
(4) Bracket without plate
(5) Adjustment screw for the rocker arm
Illustration 2 | g00686309 |
(6) Bracket
(7) Roll pin
The roll pin aligns with oil hole (11) in the front of the cylinder head. The roll pin ensures that the bracket is in the correct position on the rocker shaft.
(8) End of the adjustment screw which fits in the end of pushrod (10)
(9) Stud for mounting brackets (6)
(10) Pushrod
(11) Oil hole in the front of the cylinder head
Illustration 3 | g00686306 |
(12) Rocker arm
- Rocker arm bore ... 22.013 to 22.051 mm (0.8667 to 0.8681 inch)
- Rocker arm clearance on the rocker shaft ... 0.026 to 0.084 mm (0.0010 to 0.0033 inch)
- Maximum permissible clearance ... 0.124 mm (0.0049 inch)