Accessory Drive (Front) - Disassemble
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 1P-0520 | 冲头总成 | 1 |
开始:
- 拆卸附件驱动器（前）。 参考拆解与组装, "附件驱动器（前）- 拆卸"。
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将 O 形密封圈 (2) 和 (3) 从后接头组件 (1) 上拆下。
Show/hide table
图 2 g01255143 - 将密封件 (4) 从后适配器组件 (1) 上拆下。
- 使用工具 (A) 和适当的压具将轴承 (5) 从后适配器组件 (1) 上拆下。
Show/hide table
图 3 g01255146 - 将螺栓 (7) 和齿轮 (8) 从轴 (6) 上拆下。
Show/hide table
图 4 g01255149 - 拆下螺栓和固定垫圈 (10)。
注: 之后的机型有两个固定垫圈。
- 将轴 (6) 从前适配器组件 (9) 上拆下。
Show/hide table
图 5 g01255150 - 从前适配器组件 (9) 上拆下 O 形密封圈 (12) 和 (13)。
- 使用工具 (A) 和适当的压具以将轴承 (11) 从前接头组件 (9) 上拆下。
Show/hide table
图 6 g06095594 - 将衬套 (14) 从轴 (6) 上卸下。
Show/hide table
| |
| 图 1 | g00906726 |
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Rear) - Install
938G Wheel Loader and IT38G Integrated Toolcarrier Implement Restraint (Roading)
Installation Instructions for Mounting Cab Visors onto Cab Windows{7301} Installation Instructions for Mounting Cab Visors onto Cab Windows{7301}
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Engine Oil Filter Base
539 Knuckleboom Loader Hydraulic System Relief Valve (Line) - Test and Adjust
3304B and 3306B Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
789C Off-Highway Truck Power Train Tire and Rim (Rear) - Install
3524B Engine for Caterpillar Built Machines Gear Group (Rear) - Install
365B Excavator Cab Air Filter (Fresh Air) - Clean/Replace
416C, 426C, 428C, 436C and 438C Backhoe Loaders Transmission Electronic Control System Troubleshooting Diagnostic Codes
416C, 426C, 428C, 436C and 438C Backhoe Loaders Transmission Electronic Control System CID 0683 FMI 06 Relay (Parking Brake) Current Above Normal - Test
3524B Engine for Caterpillar Built Machines Gear Group (Rear) - Remove
CB-634C Vibratory Compactor Cooling System Coolant (DEAC) - Change
797 Off-Highway Truck Fan Drive Hydraulic System Fan Drive Hydraulic System
539 Knuckleboom Loader Hydraulic System Relief Valve (Delimber and Stabilizer Load Sensing) - Test and Adjust
3512B and 3516B Engines Engine Design
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Feeder Control Sensor
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft - Remove
3524B Engine for Caterpillar Built Machines Accessory Drive (Front) - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Water Pump
Challenger 65C, Challenger 65D, Challenger 65E, Challenger 70C, Challenger 75C, Challenger 75D, Challenger 75E, Challenger 85C, Challenger 85D, Challenger 85E and Challenger 95E Agricultural Tractors Machine Performance Panel Testing and Adjusting
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Glow Plugs - Remove and Install
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Pump - Install