Engine Oil Filter Base
发动机安装式底座
Show/hide table
 | |
| 图 1 | g00291396 |
典型实例 | |
(1) 9L-9188 弹簧 位于滤清器旁通阀内：
- 外径 ... 11.2 mm (0.44 in)
- 自由长度 ... 57.9 mm (2.28 in)
- 组装后的长度 ... 43.2 mm (1.70 in)
- 组装长度上的负载 ... 15.6 ± 1.3 N (3.50 ± 0.30 lb)
- 自由长度 ... 57.9 mm (2.28 in)
(2) 机油滤清器旁通阀必须在以下压力下打开。 ... 125 ± 30 kPa (18 ± 4.5 psi)
(3) 将 9S-3263 螺纹固定剂 涂敷在螺柱基部螺纹的最后 7.5 ± 1.5 mm (0.30 ± 0.06 in) 处。
将螺柱拧紧至以下扭矩。 ... 68 ± 7 N·m (50 ± 5 lb ft)
(4) 在滤清器油封上涂敷清洁的发动机机油。 拧紧滤清器，直到密封件与底座接触。 在密封件接触到底座后，转动滤清器 270 度。
远程安装式底座
Show/hide table
 | |
| 图 2 | g00587647 |
典型实例 | |
Show/hide table
 | |
| 图 3 | g00587684 |
A-A 视图 | |
(1) 将螺母拧紧至以下扭矩。 ... 150 ± 20 N·m (111 ± 15 lb ft)
(2) 过滤后的机油
(3) 未经过滤的机油
Caterpillar Information System:
539 Knuckleboom Loader Hydraulic System Relief Valve (Line) - Test and Adjust
3304B and 3306B Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
789C Off-Highway Truck Power Train Tire and Rim (Rear) - Install
3524B Engine for Caterpillar Built Machines Gear Group (Rear) - Install
365B Excavator Cab Air Filter (Fresh Air) - Clean/Replace
416C, 426C, 428C, 436C and 438C Backhoe Loaders Transmission Electronic Control System Troubleshooting Diagnostic Codes
416C, 426C, 428C, 436C and 438C Backhoe Loaders Transmission Electronic Control System CID 0683 FMI 06 Relay (Parking Brake) Current Above Normal - Test
3524B Engine for Caterpillar Built Machines Gear Group (Rear) - Remove
CB-534C and CB-634C Vibratory Compactors Vibratory System Drum (Split)
345B Excavator Bucket Tips - Inspect/Replace
CB-634C Vibratory Compactor Circuit Breakers - Reset
416C, 426C, 428C, 436C and 438C Backhoe Loaders Transmission Electronic Control System CID 0683 FMI 05 Relay (Parking Brake) Current Below Normal - Test
Installation Instructions for Mounting Cab Visors onto Cab Windows{7301} Installation Instructions for Mounting Cab Visors onto Cab Windows{7301}
938G Wheel Loader and IT38G Integrated Toolcarrier Implement Restraint (Roading)
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Rear) - Install
3524B Engine for Caterpillar Built Machines Accessory Drive (Front) - Disassemble
CB-634C Vibratory Compactor Cooling System Coolant (DEAC) - Change
797 Off-Highway Truck Fan Drive Hydraulic System Fan Drive Hydraulic System
539 Knuckleboom Loader Hydraulic System Relief Valve (Delimber and Stabilizer Load Sensing) - Test and Adjust
3512B and 3516B Engines Engine Design
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Feeder Control Sensor
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft - Remove
3524B Engine for Caterpillar Built Machines Accessory Drive (Front) - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install