Illustration 1 | g00734738 |
Rotation of the pump is counterclockwise when the pump is viewed from the drive end.
Type of pump: Gear
Lubricate the pump with oil before you operate the pump.
Note: The pump must rotate freely by using your hand.
Bench test requirements: SAE 10W oil must be stabilized at
(1) Transmission lubrication section
- Output ...
566 L/min (150 US gpm) - Test pressure ...
480 kPa (70 psi) - Test speed for the pump ... 1800 rpm
- Test pressure ...
(2) Torque converter charging section
- Output ...
584 L/min (155 US gpm) - Test pressure ...
930 kPa (135 psi) - Test speed for the pump ... 1800 rpm
- Test pressure ...
(3) Clearance between a new gear and a new body ...
(4) Gear
(5) Clearance between a new gear and a new cover ...
(6) Dimension of new shafts and of new pump bodies
- Diameter of the drive shafts and diameter of the driven shafts ...
50.795 ± 0.005 mm (1.9998 ± .0002 inch) - Diameter of the bearing in the pump body ...
50.878 ± 0.035 mm (2.00307 ± 0.00138 inch) - Diameter of the bearing in the pump body ...
(7) Keys
Note: Make sure that gear (4) slides freely on two keys (7).
Illustration 2 | g00877195 |
(8) Depth of bearings into cover ...
(9) Location of the bearing joint from the vertical centerline ... 30 ± 15 degrees
Illustration 3 | g00877201 |
(10) Location of the bearing joint from the vertical centerline ... 30 ± 15 degrees
(11) Depth of three dampers (B) into body ...
(12) Measurement from end of the dowel to the face of the body ...
Note: This measurement is for all four dowels that are located in the body.
(13) Depth of two dampers (A) into body ...
(14) Depth of bearings into body ...
(15) Depth of damper (C) into body ...
Illustration 4 | g00877202 |
(16) Location of the bearing joint from the vertical centerline ... 30 ± 15 degrees
(17) Depth of bearings into cover ...