Do Not Operate
Illustration 2 | g00869456 |
This warning is located on the right window inside the cab.
DO NOT OPERATE OR WORK ON THIS MACHINE UNLESS YOU HAVE READ AND UNDERSTAND THE INSTRUCTIONS AND WARNINGS IN THE OPERATION AND MAINTENANCE MANUALS. FAILURE TO FOLLOW THE INSTRUCTIONS OR HEED THE WARNINGS COULD RESULT IN INJURY OR DEATH. CONTACT ANY CATERPILLAR DEALER FOR REPLACEMENT MANUALS. PROPER CARE IS YOUR RESPONSIBILITY. |
ROPS/FOPS Structure
Illustration 3 | g00869456 |
This warning is located at the front of the floor inside the cab.
Personal injury or death can result when voiding this certification. Structural damage, an overturn, modification, alteration, or improper repair can impair the ROPS structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. To avoid possible weakening of this ROPS, consult a Caterpillar dealer before altering this ROPS in any way. The protection offered by this ROPS will be impaired if it has been subjected to structural damage. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification. |
"Rollover (ROPS) and Falling Object (FOPS) Protective Structure Certification"
"This structure, when properly installed on a machine which is not altered to exceed the certification test mass meets, at the time of installation, criteria established by: SAE J397 OCT 95, SAE J1040 MAY 94, ISO 3164: 1995, ISO 3471: 1994, ISO 8082: 1994, SAE J231 JAN 81, ISO 3449: 1992 LEVEL II, ISO 8083: 1989, SAE J1084 FEB 78, ISO 8084: 1993, WCB G603."
Maximum Height and Reach
Illustration 4 | g00869456 |
The warning is located on the rear window inside the cab.
Illustration 5 | g00711970 |
Know the maximum height of your machine and the maximum reach of your machine.
Serious injury or death by electrocution can occur if the machine or any attachments are not kept at a safe distance from electrical power lines.
Ladder
Illustration 6 | g00887366 |
This warning is located on the front of the machine near the ladder.
Illustration 7 | g00577115 |
Stay clear of the ladder when the operator is starting the machine and when the operator is stopping the machine. The ladder is automatically raised when the parking brake is disengaged. The ladder is automatically lowered when the parking brake is engaged.
Radiator
Illustration 8 | g00887370 |
Open the engine hood. This warning is located on both sides of the machine on the radiator.
Illustration 9 | g00576688 |
PRESSURIZED SYSTEM: HOT COOLANT CAN CAUSE SERIOUS BURN. TO OPEN CAP, STOP ENGINE, WAIT UNTIL RADIATOR IS COOL. THEN LOOSEN CAP SLOWLY TO RELIEVE THE PRESSURE. |
Bottom Guard
Illustration 10 | g00887371 |
Open the engine hood. The warning label is located on both sides at the front of the machine near the radiator.
Illustration 11 | g00869934 |
Do not allow personnel under the machine when you lower the bottom guard. There is no clearance for personnel when the bottom guard is lowered. Severe injury or death can occur.
Trip Point
Illustration 12 | g00887384 |
This warning label is located near the disconnect switches.
Illustration 13 | g00576296 |
This label warns the operator of a trip point. When you exit the cab, watch for objects that may be protruding.
Seat Belt
Illustration 14 | g00879908 |
This warning is located on the inside of the cab. The warning is on the left side of the front dash panel.
Illustration 15 | g00880309 |
This label warns the operator of personal injury if the seat belt is not worn. In order to avoid severe injury or death, the operator should always wear the seat belt.
Cab Tilting
Illustration 16 | g00887400 |
This warning label is located near the disconnect switches.
Do not tilt the cab when occupied. Before tilting the cab remove all loose articles from the cab, secure all windows and emergency exits, and then close the cab and cab riser doors. Failure to do so can result in personal injury or damage to the machine. |
No Clearance
Illustration 17 | g00887383 |
This warning is located near the articulation joint on both sides of the machine.
Illustration 18 | g00038790 |
No clearance for person in this area when machine turns. Severe injury or death from crushing could occur. |
"Connect the steering frame lock between the front and the rear frame. Connect the steering frame lock before lifting. Connect the steering frame lock before transporting. Connect the steering frame lock before the machine is serviced near the articulation pivot."
"Disconnect steering frame lock and secure the steering frame lock before resuming operation."
Swinging Boom
Illustration 19 | g00887381 |
This warning is located on the gate on both sides of the machine.
Illustration 20 | g00576914 |
Working Area
Illustration 21 | g00870018 |
This warning is located on both sides of the boom.
Illustration 22 | g00870022 |
This label shows the working area of the boom. To avoid injury from a swinging boom and flying debris, personnel should stay at least 70 m (225 ft) from the machine while the machine is operating. Falling trees or other debris can cause severe injury or death.
Battery
Illustration 23 | g00870028 |
This warning is located near the batteries. The batteries are located under the cab.
Illustration 24 | g00576858 |
Do not attempt to jump start the machine until you read the instructions in the Operation and Maintenance Manual.
High Pressure Accumulator
Illustration 25 | g00870044 |
This warning is located under the cab.
Illustration 26 | g00870085 |
This label warns service personnel of a high pressure accumulator. Do not attempt to work on this accumulator until you read the service manual.