Illustration 1 | g00382952 |
(1) Mounting bolt and bypass valve
The bypass valve in the oil filter base opens at the following pressure. ... 55 to 83 kPa (8 to 12 psi)
Tighten the mounting bolt to the following torque. ... 80 N·m (59 lb ft)
(2) O-rings
Use new O-rings when the oil filter base is installed. When the O-rings are installed, put a thin film of clean engine oil on the O-rings.
(3) Mounting face on the right side of the cylinder block
(4) Filter base
Note: Some engine installations on Caterpillar machines may have a different oil filter base assembly. The oil filter base is connected to the same location by a connection fitting. However, the location of the oil filter base assembly may be on a special bracket which is mounted on the engine or remote to the engine. The bypass valve is located in the oil filter base assembly.