Engine Oil Level - Check
Show/hide table
| NOTICE |
|---|
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage. |
- The machine must be on a level surface and the parking brake must be engaged.
Show/hide table
 | |
| Illustration 1 | g00353195 |
Show/hide table
 | |
| Illustration 2 | g00418018 |
- When the engine is running at low idle, maintain the oil level between the "ADD" mark and the "FULL" mark. These marks are on the "LOW IDLE" side of dipstick (2) .
- When the engine is stopped, maintain the oil level between the "ADD" mark and the "FULL" mark. These marks are on the "ENGINE STOPPED" side of dipstick (2) .
- If necessary, remove oil filler cap (1) and add oil.
- Clean the filler cap and install the filler cap.
Caterpillar Information System:
CP-563D, CS-563D, CS-573D and CS-583D Paving Compactors Roading the Machine
572R Pipelayer Undercarriage
IT14G Integrated Toolcarrier and 914G Wheel Loader Braking System Flow Switch
550, 570 and 580 Wheel Harvesters Pendulum Arm Cylinder Bearings - Lubricate
CP-563C and CS-563C Vibratory Compactors Shipping the Machine
527 Track-Type Skidder Cooling System Level - Check
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Minimizing Soil Disturbance
550, 570 and 580 Wheel Harvesters Pendulum Arm Bearings - Lubricate
CP-563C and CS-563C Vibratory Compactors Leaving the Machine
CP-563C and CS-563C Vibratory Compactors Equipment Lowering with Engine Stopped
416C, 426C, 428C, 436C and 438C Backhoe Loaders Axles, Differential and Brakes Brake System Air - Purge
789C Off-Highway Truck Power Train Torque Converter Inlet and Outlet Relief Valves
527 Track-Type Skidder Fuel Tank Water and Sediment - Drain
572R Pipelayer Track Idler
527 Track-Type Skidder Brakes, Indicators, Gauges and Horn - Test
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Vane Pump (Implement, Pilot and Braking) - Remove
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Vane Pump (Implement, Pilot and Braking) - Install
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Pump Control Valve (Steering) - Remove and Install
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Piston Pump (Steering) - Remove
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Piston Pump (Steering) - Install
966G Wheel Loader and 972G Wheel Loader Power Train CID 0622 FMI 03 Push Button Switch (Upshift) Voltage Above Normal - Test
966G Wheel Loader and 972G Wheel Loader Power Train CID 0623 FMI 03 Rocker Switch (Transmission Direction) Voltage Above Normal - Test
966G Wheel Loader and 972G Wheel Loader Power Train CID 0623 FMI 04 Rocker Switch (Transmission Direction) Voltage Below Normal - Test
966G Wheel Loader and 972G Wheel Loader Power Train CID 0631 FMI 07 Modulating Valve (Clutch 1 Solenoid) Improper Mechanical Response - Test