Usage:
(1) Stud. Put 9S3263 Thread Sealant on the stud.
(2) Studs. Tighten studs to a torque of ... 25 ± 5 N·m (18 ± 4 lb ft)
(3) Stud. Tighten stud to a torque of ... 25 ± 5 N·m (18 ± 4 lb ft)
(4) Plate. Remove excessive oil, fuel, and water from front face of timing gear housing, both faces of plate and mounting face of fuel pump gear cover. Apply a continuous bead of liquid gasket inside the bolt hole pattern.
4N6798
4N6798 Timing Gear Housing Cover
(1) Torque for stud on back of the housing ... 20 ± 3 N·m (15 ± 12 lb ft)
(2) Put 9S3263 Thread Lock on threads of stud.
Dimension stud must be extended from surface of timing gear housing ... 73.2 mm (2.88 in)
(3) Torque for three studs ... 20 ± 3 N·m (15 ± 2 lb ft)
(4) Put 5P3413 Pipe Sealant on the threads of two studs for installation in the housing. Dimension from top of studs to housing ... 28.5 mm (1.12 in)
NOTE: Cut the gasket between the timing gear cover and the block even with the bottom of the timing gear cover after assembly.
111-7822
111-7822 Front Cover
(1) Torque for stud on back of the housing ... 35 ± 5 N·m (26 ± 4 lb ft)
(2) Put 9S3263 Thread Lock on threads of stud.
Dimension stud must be extended from surface of timing gear housing ... 73.2 mm (2.88 in)
(3) Torque for three studs ... 35 ± 5 N·m (26 ± 4 lb ft)
(4) Put 5P3413 Pipe Sealant on the threads of two studs for installation in the housing. Dimension from top of studs to housing ... 28.5 mm (1.12 in)
NOTE: Cut the gasket between the timing gear cover and the block even with the bottom of the timing gear cover after assembly.