Usage:
(1) Torque for primary fuel filter nut ... 25 ± 7 N·m (20 ± 5 lb ft)
(2) Put 9S3265 Retaining Compound on the tapered end of stud to a distance of ... 7.6 mm (.30 in)
(3) Distance from sealing surface of base to end of stud ... 24.6 ± 1.2 mm (.97 ± .05 in)
(4) Sealing surface of stud.
NOTE: Do not damage this surface.
(5) Torque for stud ... 70 ± 14 N·m (50 ± 10 lb ft)
(6) 7S9323 Spring:
Length under test force ... 27.9 mm (1.10 in)
Test force ... 123 to 144 N (27.7 to 32.4 lb)
Free length after test ... 42.7 mm (1.68 in)
Outside diameter ... 17.3 mm (.68 in)
(7) Secondary fuel filter.
(1) Stud (two) used when filter base is installed high on the inlet manifold. Install stud so end of stud extends above surface of manifold boss to a dimension of ... 24.3 ± 1.5 mm (.96 ± .06 in)
(2) Put 9S3265 Retaining Compound on the tapered end of stud to a distance of ... 7.6 mm (.30 in)
(3) Sealing surface of stud.
NOTE: Do not damage this surface.
(4) Distance from sealing surface of base to end of stud ... 24.6 ± 1.3 mm (.97 ± .05 in)
(5) Torque for stud ... 70 ± 14 N·m (50 ± 10 lb ft)