Usage:
1. Remove the oil from the tandem housings and the bevel gear case to a level below the axles.
2. Remove bolts (2). Remove cover (1) and the gasket from the tandem housing.
3. Remove bolts (4) and washers (5) that hold retainer (3).
4. Install the 3/8" - 16 NC forcing screws in the retainer. Remove retainer (3) with forcing screws (6).
5. Remove O-ring seal (7) from the retainer.
6. Install a 1/2" - 13 NC forged eyebolt in the end of the axle. Remove axle (8).
7. Install tooling (A) on axle and remove bearing (9).
8. Repeat Steps 1 through 7 for the other axle.
Install Axles
1. Heat axle bearing (2) to a temperature of 275° F (135° C) and install it on axle (1).
2. Put axle in position in the final drive.
3. Install the axle in the final drive and differential. The axle must be turned to put the splines on the axle in alignment with the splines in the final drive and differential.
4. Install O-ring seal (4) on retainer (3).
5. Put retainer (3) in position on the final drive. Install washers (5) and bolts (6) that hold the retainer to the final drive.
6. Install cover (7) on the tandem housing.
7. Fill the tandem housing and the bevel gear case with oil to the correct level.
8. Repeat Steps 1 through 7 for the other axle.