1982/03/22 Caterpillar


Caterpillar Electric Starting Motors{1453,1407}

Usage:


3204, 3304 and 3306 Vehicular Engines;
3306 Industrial Engines

SUPPLEMENT: 09/20/82

SERVICE MAGAZINE, MARCH 22, 1982, PAGE 4. In the article "Caterpillar Electric Starting Motors" some of the information in Chart B has changed. Changes were made to Items 1, 4, 7, 8 and 12. An additional part number was added to Item 1. One of the part numbers was removed from Item 4. Items 7, 8 and 12 are not available for parts service.

--------------- END SUPPLEMENT ---------------

Some of the above engines are equipped with either a Caterpillar, Delco-Remy or Prestolite starting motor and solenoid. If a replacement starting motor group is ordered, it is possible to get any one of these starting motor groups. For each individual engine the Caterpillar, Delco-Remy, and Prestolite starting motor groups are interchangeable (direct replacements). But, the parts within these three groups are not interchangeable.

The current Parts Books do not show the Caterpillar starting motor groups or their individual components.


Location of parts.

Identification of the Caterpillar starting motors can be made by either of the numbers shown in Chart A.

Chart B shows the separate components of the Caterpillar starting motors. Chart C shows the repair kits that are available for these starting motors.

Caterpillar Information System:

1982/03/22 Use 5P5195 Fuel Line Wrench Correctly{0612,1252}
1982/03/22 Engine Replacement{1000}
1982/03/22 Use Correct Torque On Hydraulic Valve Bolts, Nuts And Taperlock Studs{5050}
1982/03/22 Carbon Build-Up In Combustion And Inlet Areas{1058,1101,1105,1214,1104}
1982/03/15 Service Parts Available For 6G7650 Seat{7312,7307,7321}
1982/03/15 New Stem And Springs In Overspeed Valves Permit Operation Down Steeper Grades Without Track Motor Damage{5051,5451,5474}
1982/03/15 New O-Ring Seal Used On Cartridge-Type Relief Valves Has Better Resistance To Damage{5050,3200}
1982/03/15 Use The 6V6059 Microlite With The 6V2196 Inspection Microscope{0651}
1982/03/15 New Diaphragm Used In Fuel Ratio Control{1278}
1982/03/15 Difference Between Static And Dynamic Rack Settings Changed{0374,1257}
1982/03/15 New Crankshaft Has Wider Main Journals; Wider Main Bearings{1202,1203}
1982/03/15 More Flexible Hose For Use With Hydraulic Flowmeter{0651,5050}
1982/03/22 New Bracket Prevents Damage To Horn Wires{7303}
1982/03/22 Correct Use Of 6V2023 Flow Check Adapter Group Is Important To Prevent Damage To An Engine{0651,0654,1250}
1982/03/29 Parts Book Changes{0374}
1982/03/29 Location Of Sending Unit Changed To Improve Accuracy Of Water Temperature Indication{7453}
1982/03/29 FT1667 And FT1668 Beam Assemblies For Undercarriage Removal{0642,0643,4150}
1982/03/29 Multi-Piece Wheel Rims; Caution Must Be Used{4202,4201}
1982/03/29 Increased Clearance Between Hoist Cylinder Assembly And Rod{5102,7258}
1982/03/29 Twisted Port Plate Can Cause Excessive Case Drain From Piston Pump Or Motor{5058,5070}
1982/04/05 Use FT1631 Flare Nut Wrench For Connector In Bulldozer Lift Circuit{0610,0611,0623}
1982/04/05 Lubricant Recommendations Have Been Changed For Vehicular Products{0680,0374,0375,3004,1318,5060}
1982/04/05 New Outer Duo-Cone Seal Groups Used In Service And Parking Brake Groups{4208,4251,4267}
1982/04/12 New Clearance Specification Used In Torque Converter{3101}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.