1982/03/22 Caterpillar


Use 5P5195 Fuel Line Wrench Correctly{0612,1252}

Usage:


The 5P5195 Fuel Line Wrench is used to tighten the nuts on some fuel lines. It is possible to damage the crowfoot end of the wrench if it is not used correctly. The wrench can be damaged if a torque value of more than approximately 40 N·m (30 lb ft) is used.

Caterpillar Information System:

1982/03/22 Engine Replacement{1000}
1982/03/22 Use Correct Torque On Hydraulic Valve Bolts, Nuts And Taperlock Studs{5050}
1982/03/22 Carbon Build-Up In Combustion And Inlet Areas{1058,1101,1105,1214,1104}
1982/03/15 Service Parts Available For 6G7650 Seat{7312,7307,7321}
1982/03/15 New Stem And Springs In Overspeed Valves Permit Operation Down Steeper Grades Without Track Motor Damage{5051,5451,5474}
1982/03/15 New O-Ring Seal Used On Cartridge-Type Relief Valves Has Better Resistance To Damage{5050,3200}
1982/03/15 Use The 6V6059 Microlite With The 6V2196 Inspection Microscope{0651}
1982/03/15 New Diaphragm Used In Fuel Ratio Control{1278}
1982/03/15 Difference Between Static And Dynamic Rack Settings Changed{0374,1257}
1982/03/15 New Crankshaft Has Wider Main Journals; Wider Main Bearings{1202,1203}
1982/03/15 More Flexible Hose For Use With Hydraulic Flowmeter{0651,5050}
1982/03/08 Improved Circle Drive Housing{5207}
1982/03/22 Caterpillar Electric Starting Motors{1453,1407}
1982/03/22 New Bracket Prevents Damage To Horn Wires{7303}
1982/03/22 Correct Use Of 6V2023 Flow Check Adapter Group Is Important To Prevent Damage To An Engine{0651,0654,1250}
1982/03/29 Parts Book Changes{0374}
1982/03/29 Location Of Sending Unit Changed To Improve Accuracy Of Water Temperature Indication{7453}
1982/03/29 FT1667 And FT1668 Beam Assemblies For Undercarriage Removal{0642,0643,4150}
1982/03/29 Multi-Piece Wheel Rims; Caution Must Be Used{4202,4201}
1982/03/29 Increased Clearance Between Hoist Cylinder Assembly And Rod{5102,7258}
1982/03/29 Twisted Port Plate Can Cause Excessive Case Drain From Piston Pump Or Motor{5058,5070}
1982/04/05 Use FT1631 Flare Nut Wrench For Connector In Bulldozer Lift Circuit{0610,0611,0623}
1982/04/05 Lubricant Recommendations Have Been Changed For Vehicular Products{0680,0374,0375,3004,1318,5060}
1982/04/05 New Outer Duo-Cone Seal Groups Used In Service And Parking Brake Groups{4208,4251,4267}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.