Remanufactured Clutch Plates Available For Power Shift Transmissions{3155,0375}
Usage:
Remanufactured clutch plates are available for Caterpillar power shift transmissions. The quality, expected service life, and warranty for these clutch plates are the same as new plates, but the cost is much lower. For this reason, the use of remanufactured clutch plates will lower the cost of transmission reconditioning and the customer's cost of operation.
The chart shows the form numbers of Technical Parts-grams and Guidelines For Reusable Parts which will be of assistance in the use of remanufactured clutch plates. These forms can be ordered for use as reference material.
Caterpillar Information System:
1981/06/08 Troubleshooting Water In Shut-Off Solenoid Housing{1259}
1981/06/08 Spring-Activated Brake Lock (Parking Brake) Now Used{4115,4114,4112,4111}
1981/06/08 Inspect Piston Skirts During Engine Overhaul Procedures{1214,1213}
1981/06/01 Some Single Part Numbers Have Two Half Bearings{7551}
1981/06/01 Correct Use Of Keystone Ring Groove Gauges{1214,1215,1312,0653}
1981/05/25 Use FT1612 Pump Tool To Adjust Servo Valve In Piston Type Hydraulic Pump{0654,5070}
1981/05/25 Stronger Studs, Increased Torque Now Used In Front Wheel Brake Group{4251}
1981/05/25 Washer Added Between Bolt And Thrust Plate For Oil Pump Idler Gear{1206}
1981/05/25 Use Correct Specifications To Check Piston Ring Gaps{1215}
1981/05/25 Instruction Cards For "Go-No Go" Gauges Now Available{0653}
1981/05/25 New Tube Assemblies Used In Brake Oil Cooler Lines Group{4257,5057,1365}
1981/05/18 New Mounting Group For Overspeed Switch{7410}
1981/06/15 New Recommendation To Check Nitrogen Charge In Transmission Accumulators{3167}
1981/06/15 Plastic Cases Now Available For Electronic Testing And Diagnostic Equipment{0630,0650}
1981/06/15 Supplemental Steering Now Automatically Activated{4324,4306,4307}
1981/06/15 Change To 6V95 Socket; Modification Of Existing Sockets{0612}
1981/06/22 6V3145 Leveler Now Available{0644}
1981/06/22 Cylinder Liners Can Now Be Reconditioned Automatically{0664,0674,1216}
1981/06/22 New Blade Tip Brackets Used With New Circle And Beam Assembly For Stronger Blade Support{5254,6154}
1981/06/29 Tools To Check Fuel Injection Timing By The Fuel Flow Method{0651,1000,1250}
1981/06/29 Improvements Give Added Strength To Main Frame{7051}
1981/06/29 Ring Now Used To Hold Bearing In Auxiliary Drive Group{1165}
1981/06/29 New Gasket Used In Front Housing Group{1166,1162,1151}
1981/06/29 Changes Made To Brake Lines And Brake Oil Cooler Lines{4257,1365,5057}