Transmission Oil Cooler - Remove and Install
Reference: Special Instruction, "Visual Service Procedures - Colors and Symbols" , M0066576.
Start By:
- Remove the transmission oil pressure sensor.
- Remove the transmission oil temperature sensor.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the sea water feed to the OFF position.
- For Keel cooled, drain the coolant from the circuit.
Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
| |
| Illustration 1 | g06261551 |
Show/hide table
| |
| Illustration 2 | g06261553 |
- Install the transmission oil cooler in the reverse order of removal.
Caterpillar Information System:
C7.1 Marine Propulsion Engine Transmission Oil Temperature Sensor - Remove and Install
C7.1 Marine Propulsion Engine Transmission Oil Pressure Sensor - Remove and Install
793F Off-Highway Truck Engine Supplement Diesel Exhaust Fluid Filter - Remove and Install
3516C HD Generator Set with Gearbox Reference Information
C175 Tier 4 Final Engines for Caterpillar Built Machines Catalyst (SCR) - Remove and Install
793F Off-Highway Truck Engine Supplement Nitrogen Oxide Sensor (Exhaust Inlet) - Remove and Install
PVT120 Photovoltaic Modules Module - Inspect
3516C HD Generator Set with Gearbox Drive Gearbox Oil - Change
PVT110, PVT115 4V3 and PVT117 4V3 Photovoltaic Modules Module - Inspect
C7.1 Marine Propulsion Engine Aftercooler - Remove and Install
3516C HD Generator Set with Gearbox Drive Gearbox Oil Sample - Obtain
3516C HD Generator Set with Gearbox Drive Gearbox Oil Heater - Test
C7.1 Marine Propulsion Engine Auxiliary Water Pump - Remove and Install
3516C HD Generator Set with Gearbox General Hazard Information
New Diesel Exhaust Fluid Pump Connector is Now Used on Certain C7.1 - C18 Engine Applications {108J} New Diesel Exhaust Fluid Pump Connector is Now Used on Certain C7.1 - C18 Engine Applications {108J}
336 Excavators (Powered by C9.3 Tier 4 Engine) Engine Supplement Valve Mechanism Cover - Remove and Install
Improved Camera is Now Used on Certain Cat® Products {1408} Improved Camera is Now Used on Certain Cat® Products {1408}
C7.1 Marine Propulsion Engine Auxiliary Water Pump - Disassemble
C7.1 Marine Propulsion Engine Auxiliary Water Pump - Assemble
C7.1 Marine Propulsion Engine Electric Starting Motor - Remove and Install
C7.1 Marine Propulsion Engine Flywheel - Remove and Install
Selective Catalytic Reduction Retrofit Aftertreatment Diesel Particulate Filter - Remove and Install - If Equipped
Retrofitting for the Dynamic Gas Blending Capability on Certain 3516B Engines {1071, 1100, 1250, 1270, 1274, 1403, 1716, 1901, 1920} Retrofitting for the Dynamic Gas Blending Capability on Certain 3516B Engines {1071, 1100, 1250, 1270, 1274, 1403, 1716, 1901, 1920}
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Stopping the Machine