Transmission Oil Temperature Sensor - Remove and Install
Reference: Special Instruction, "Visual Service Procedures - Colors and Symbols" , M0066576.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g06261830 |
Show/hide table
Illustration 2 | g06261831 |
Caterpillar Information System:
C7.1 Marine Propulsion Engine Transmission Oil Pressure Sensor - Remove and Install
793F Off-Highway Truck Engine Supplement Diesel Exhaust Fluid Filter - Remove and Install
3516C HD Generator Set with Gearbox Reference Information
C175 Tier 4 Final Engines for Caterpillar Built Machines Catalyst (SCR) - Remove and Install
793F Off-Highway Truck Engine Supplement Nitrogen Oxide Sensor (Exhaust Inlet) - Remove and Install
PVT120 Photovoltaic Modules Module - Inspect
3516C HD Generator Set with Gearbox Drive Gearbox Oil - Change
PVT110, PVT115 4V3 and PVT117 4V3 Photovoltaic Modules Module - Inspect
C7.1 Marine Propulsion Engine Aftercooler - Remove and Install
3516C HD Generator Set with Gearbox Drive Gearbox Oil Sample - Obtain
3516C HD Generator Set with Gearbox Drive Gearbox Oil Heater - Test
3516C HD Generator Set with Gearbox Drive Gearbox Oil Level - Check
C7.1 Marine Propulsion Engine Transmission Oil Cooler - Remove and Install
C7.1 Marine Propulsion Engine Auxiliary Water Pump - Remove and Install
3516C HD Generator Set with Gearbox General Hazard Information
New Diesel Exhaust Fluid Pump Connector is Now Used on Certain C7.1 - C18 Engine Applications {108J} New Diesel Exhaust Fluid Pump Connector is Now Used on Certain C7.1 - C18 Engine Applications {108J}
336 Excavators (Powered by C9.3 Tier 4 Engine) Engine Supplement Valve Mechanism Cover - Remove and Install
Improved Camera is Now Used on Certain Cat® Products {1408} Improved Camera is Now Used on Certain Cat® Products {1408}
C7.1 Marine Propulsion Engine Auxiliary Water Pump - Disassemble
C7.1 Marine Propulsion Engine Auxiliary Water Pump - Assemble
C7.1 Marine Propulsion Engine Electric Starting Motor - Remove and Install
C7.1 Marine Propulsion Engine Flywheel - Remove and Install
Selective Catalytic Reduction Retrofit Aftertreatment Diesel Particulate Filter - Remove and Install - If Equipped
Retrofitting for the Dynamic Gas Blending Capability on Certain 3516B Engines {1071, 1100, 1250, 1270, 1274, 1403, 1716, 1901, 1920} Retrofitting for the Dynamic Gas Blending Capability on Certain 3516B Engines {1071, 1100, 1250, 1270, 1274, 1403, 1716, 1901, 1920}