Nitrogen Oxide Sensor - Remove and Install
参考: 专门说明书, "目视维修步骤 - 颜色和符号" , M0066576。
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 468-8116 | 槽型插座 | 1 |
B | - | Loctite C5A 铜制品防咬合剂 | - |
注: 确保氮氧化物传感器没有跌落或受到撞击。 如果氮氧化物传感器跌落或受到撞击,必须整体更换氮氧化物传感器。
Show/hide table
图 1 | g06239858 |
Show/hide table
图 2 | g06239878 |
Show/hide table
图 3 | g06240279 |
Show/hide table
图 4 | g06240284 |
- 按与拆卸相反的顺序安装氮氧化物传感器。
Show/hide table
图 5 | g06240266 |
仅安装旧传感器时涂抹工具 (A)。 新传感器已在螺纹上涂抹工具 (A)。 |
Show/hide table
图 6 | g06240273 |
仅安装旧传感器时涂抹工具 (A)。 新传感器已在螺纹上涂抹工具 (A)。 |
Caterpillar Information System:
C32 Marine Engines Inlet Air Temperature Sensor - Remove and Install
C32 Marine Engines Inlet Manifold Pressure Sensor - Remove and Install
C32 Marine Engines Speed/Timing Sensor - Remove and Install
320GC and 320 Excavator Engine Supplement Manifold (DEF Heater) - Remove and Install
336, 336 GC and 340 Excavator Systems Bucket Cylinder
XQ125 Generator Set Cooling System Coolant Level - Check
XQ125 Generator Set Belt Tensioner - Inspect
XQ125 Generator Set Cooling System Coolant (DEAC) - Change
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Sensor Supply - Test - Display
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Ethernet Data Link - Test
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting ECM Location Code - Test
336, 336 GC and 340 Excavator Systems Sensor (Data Link Type) - Test
336, 336 GC and 340 Excavator Systems Stick Cylinder
The Buffer Seal Groove May Wear on the Steering Cylinder Head on Certain 773G and 777G Off-Highway Trucks {4303} The Buffer Seal Groove May Wear on the Steering Cylinder Head on Certain 773G and 777G Off-Highway Trucks {4303}
C7.1 Marine Engine Exhaust Elbow - Remove and Install
C7.1 Engines Coolant Pressure Is Low
336, 336 GC and 340 Excavator Systems Pilot System
C32 Marine Engines Electronic Control Module - Remove and Install
794 AC Off-Highway Truck Magnetic Plug (Wheels) - Check
A New Service Replacement Control Board (APC1+) is Now Used on Certain Cat® Uninterrupted Power Supply {1418, 4480} A New Service Replacement Control Board (APC1+) is Now Used on Certain Cat® Uninterrupted Power Supply {1418, 4480}
New Improved Gearbox Oil Heater is Now Used on Certain G3512E, G3516H, G3520C, and G3520H Generator Sets {1333} New Improved Gearbox Oil Heater is Now Used on Certain G3512E, G3516H, G3520C, and G3520H Generator Sets {1333}
New Jacket Water Bypass Tube is Now Used on Certain C175-20 Locomotive Engines {1380} New Jacket Water Bypass Tube is Now Used on Certain C175-20 Locomotive Engines {1380}
C32 Tier 4 Final Marine Commercial Engines DEF Pump Motor - Test
A New Plate-Type Heat Exchanger is Now Available for Certain Cat® 3516C Marine Engines {1379} A New Plate-Type Heat Exchanger is Now Available for Certain Cat® 3516C Marine Engines {1379}