Belt Tensioner - Inspect
Show/hide table
| |
| Illustration 1 | g03423083 |
|
Typical example | |
Remove the belt. Refer to Disassembly and Assembly, "Alternator Belt - Remove and Install".
Ensure that the belt tensioner (1) is securely installed. Visually inspect the belt tensioner for damage. Check that the pulley on the tensioner rotates freely and that the bearing is not loose. Some engines have an idler pulley (2). Ensure that the idler pulley is securely installed. Visually inspect the idler pulley for damage. Ensure that the idler pulley can rotate freely and that the bearing is not loose. If necessary, replace damaged components.
Install the belt. Refer to Disassembly and Assembly, "Alternator Belt - Remove and Install".
Caterpillar Information System:
XQ125 Generator Set Cooling System Coolant (DEAC) - Change
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Sensor Supply - Test - Display
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting Ethernet Data Link - Test
320 GC, 320, 323, 330 GC and 330 Excavator Machine Systems Troubleshooting ECM Location Code - Test
336, 336 GC and 340 Excavator Systems Sensor (Data Link Type) - Test
XQ125 Generator Set Stopping the Engine
XQ125 Generator Set Sensors and Electrical Components
C32 Marine Engines Crankshaft Main Bearings - Install
C32 Marine Engines Engine Oil Pan - Remove and Install
New Firmware is Available for 7 inch and 13 inch Displays for Certain Marine Engines {7490, 7620} New Firmware is Available for 7 inch and 13 inch Displays for Certain Marine Engines {7490, 7620}
C9.3 Marine Auxiliary Engines Fluid Recommendations
New Software Is Now Used on Certain C18 Locomotive Engines {1920} New Software Is Now Used on Certain C18 Locomotive Engines {1920}
XQ125 Generator Set Cooling System Coolant Level - Check
336, 336 GC and 340 Excavator Systems Bucket Cylinder
320GC and 320 Excavator Engine Supplement Manifold (DEF Heater) - Remove and Install
C32 Marine Engines Speed/Timing Sensor - Remove and Install
C32 Marine Engines Inlet Manifold Pressure Sensor - Remove and Install
C32 Marine Engines Inlet Air Temperature Sensor - Remove and Install
320GC and 320 Excavator Engine Supplement Nitrogen Oxide Sensor - Remove and Install
336, 336 GC and 340 Excavator Systems Stick Cylinder
The Buffer Seal Groove May Wear on the Steering Cylinder Head on Certain 773G and 777G Off-Highway Trucks {4303} The Buffer Seal Groove May Wear on the Steering Cylinder Head on Certain 773G and 777G Off-Highway Trucks {4303}
C7.1 Marine Engine Exhaust Elbow - Remove and Install
C7.1 Engines Coolant Pressure Is Low
336, 336 GC and 340 Excavator Systems Pilot System