Hood - Remove and Install - Right
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 422-5472 | Lifting Eye Assembly | 4 |
- Raise the right-hand hood to the fully open position.
Show/hide table
Illustration 1 g06092201 - Attach a suitable lifting device to support right-hand hood (1). The weight of right-hand hood (1) is approximately
172 kg (380 lb) Show/hide tableIllustration 2 g06092208 - Remove snap ring (3). Remove retaining pin (2).
- Cut all cable straps securing harness assembly (4) to right-hand hood (1). Place harness assembly (4) out of the way.
Show/hide table
Illustration 3 g06092217 - Disconnect gas spring assembly (5).
- Using the lifting device attached in Step 2, lower the right-hand hood to the closed position. Remove the lifting device.
Show/hide table
Illustration 4 g06092536 - Remove bolts (6). Repeat process for opposite side of right-hand hood (1).
Show/hide table
Illustration 5 g06092558 - Use Tooling (A) and a suitable lifting device to remove right-hand hood (1). The weight of right-hand hood (1) is approximately
172 kg (380 lb)
- Install right-hand hood (1) in the reverse order of removal.
Caterpillar Information System:
3500B Locomotive Engines Overhaul (Major)
C11, C13, C15, and C18 Industrial Engines Sensor Signal (Analog, Passive) - Test
C13 Engines for Caterpillar Built Machines Speed Control - Test
Cat® Detect Object Detection System Related Components
Cat® Detect Object Detection System Diagnostic Summary Screen
Cat® Detect Object Detection System Configuration Screen
C11, C13, C15, and C18 Industrial Engines Sensor Supply - Test
Cat® Detect Object Detection System Main Screen
G3512 Generator Set Engines Engine Monitoring System
C13 Engines for Caterpillar Built Machines Injector Solenoid - Test
Cat® Detect Object Detection System Display
3500C Locomotive Engines Overhaul (In-Frame)
G3512 Generator Set Engines Exhaust Temperature - Test
New Engine Software Is Now Used on Certain C7.1 Generator Set {1920} New Engine Software Is Now Used on Certain C7.1 Generator Set {1920}
3516E Engines for Caterpillar Built Machines Piston and Rings
C7.1 Marine Engine Crankcase Breather - Remove
3500B Locomotive Engines Overhaul (Top End)
C7.1 Marine Engine Engine Oil Pan - Remove and Install
C7.1 Marine Engine Coolant Level Sensor - Remove and Install
Aluminum Charge Air Cover and Exhaust Gas Cooler Replacement Procedure for Certain C18 Engines {1052, 1061, 1379} Aluminum Charge Air Cover and Exhaust Gas Cooler Replacement Procedure for Certain C18 Engines {1052, 1061, 1379}
Aluminum Charge Air Cover Replacement Procedure for Certain C18 Engines {1052, 1061, 1379} Aluminum Charge Air Cover Replacement Procedure for Certain C18 Engines {1052, 1061, 1379}
An Improved Connecting Rod Bolt Is Now Used for Certain C11 and C13 Engines {1225} An Improved Connecting Rod Bolt Is Now Used for Certain C11 and C13 Engines {1225}
New Fuel Filter Base Isolation Mounts Are Now Available For Certain C13 Engines {1262} New Fuel Filter Base Isolation Mounts Are Now Available For Certain C13 Engines {1262}
G3512 Generator Set Engines Ignition Primary - Test