Model View Illustrations
以下机型视图中所示为发动机的典型特性。 由于具体应用不同,您的发动机可能看起来与图中所示有所差异。
Show/hide table
图 1 | g03343017 |
(1) 燃油细滤器
(2) 曲轴箱呼吸器软管 (3) 机油取样阀 (4) 电子控制模块 (5) 机油滤清器 (6) 机油表(油尺) (7) 机油排放塞 (8) 机油加注口盖 |
注: 发动机可能安装有一个带有滤清器的呼吸器 (30)。
Show/hide table
图 2 | g03343019 |
(9) 冷却液出口
(10) 水泵 (11) 冷却液进口 (12) 减振器 (13) 皮带张紧装置 (14) 皮带 (15) 皮带惰轮皮带轮 |
Show/hide table
图 3 | g03343041 |
(16) 排气歧管
(17) 前吊耳 (18) 交流发电机 (19) 制冷剂压缩机 (20) 涡轮增压器 (21) 起动马达 (22) 起动马达电磁阀 (23) 飞轮 (24) 飞轮壳 (25) 后吊耳 |
Show/hide table
图 4 | g06051726 |
(26) 机械充油泵
(27) 燃油粗滤器 |
Caterpillar Information System:
Installation and Configuration Procedure for an Autonomous Stop (A-Stop) System {7610, 7620} Installation and Configuration Procedure for an Autonomous Stop (A-Stop) System {7610, 7620}
C15 Generator Sets Maintenance Interval Schedule - Standby Generator Sets
C15 Generator Sets Maintenance Interval Schedule - Prime
C15 Generator Sets Maintenance Interval Schedule - Emergency Standby Power
C18 Generator Set Engines Cylinder Liner - Remove and Install
New Exhaust Gaskets Are Used on Certain 3500 Engines {1059} New Exhaust Gaskets Are Used on Certain 3500 Engines {1059}
C13, C15, and C18 Tier 4 Final Engines Diesel Exhaust Fluid Tank
3512E Petroleum Engines General Information (Fuel System)
Troubleshooting Guide for the Rotary Position Sensor for Cat® Grade Control on Certain Series E and Series F Excavators {5736} Troubleshooting Guide for the Rotary Position Sensor for Cat® Grade Control on Certain Series E and Series F Excavators {5736}
C7.1 Marine Propulsion Engine Model View Illustrations
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Fan Pump - Test and Adjust
C12.9 Marine Engines Expansion Tank - Remove and Install
C9.3 Marine Engine Fuel Manifold - Remove and Install - Single Wall Rail
3516B Generator Set Engines with Dynamic Gas Blending Electrical Connectors
C18 Generator Set Engines Piston Cooling Jets - Remove and Install
C7.1 Marine Propulsion Engine Engine Crankcase Breather - Clean
C9.3 Marine Engine Fuel Manifold (Rail) - Remove and Install - Double Wall Rail
C9.3 Marine Engine Fuel Manifold (Rail) - Remove and Install - Single Wall Rail
C9.3 Marine Engine Transmission Oil Cooler - Remove and Install
XQP150 Rental Generator Set Refill Capacities
C18 Generator Set Engines Piston and Connecting Rods - Remove and Install
XQP150 Rental Generator Set Refill Capacities
XQP150 Rental Generator Set Welding on Engines with Electronic Controls
C18 Generator Set Engines Pistons and Connecting Rods - Disassemble