Fuel Manifold - Remove and Install - Single Wall Rail
Show/hide table
| Required Tools | |||
| Tool | Pat Number | Part Description | Qty |
| A | 276-7018 | Plug/Cap Kit | 1 |
Note: All high-pressure fuel line connections to be closed with protective caps from Tooling (A)
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Turn the fuel supply to the OFF position.
Show/hide table
Illustration 1 g03826596 - Disconnect tube assembly (1).
Show/hide table
Illustration 2 g03826603 - Remove elbow assembly (4). Disconnect tube assembly (6).
- Remove bolts (2), bolt (3), and fuel manifold (5).
Show/hide table
Illustration 3 g03826618 - Remove check valve (7) and fuel sampling valve (8).
- Install fuel manifold (5) in the reverse order of removal.
- Lubricate the seals of check valve (7) with the lubricant that is being sealed.
Caterpillar Information System:
XQP150 Rental Generator Set Model View Illustrations
Installation and Configuration Procedure for an Autonomous Stop (A-Stop) System {7610, 7620} Installation and Configuration Procedure for an Autonomous Stop (A-Stop) System {7610, 7620}
C15 Generator Sets Maintenance Interval Schedule - Standby Generator Sets
C15 Generator Sets Maintenance Interval Schedule - Prime
C15 Generator Sets Maintenance Interval Schedule - Emergency Standby Power
C18 Generator Set Engines Cylinder Liner - Remove and Install
New Exhaust Gaskets Are Used on Certain 3500 Engines {1059} New Exhaust Gaskets Are Used on Certain 3500 Engines {1059}
C13, C15, and C18 Tier 4 Final Engines Diesel Exhaust Fluid Tank
3512E Petroleum Engines General Information (Fuel System)
Troubleshooting Guide for the Rotary Position Sensor for Cat® Grade Control on Certain Series E and Series F Excavators {5736} Troubleshooting Guide for the Rotary Position Sensor for Cat® Grade Control on Certain Series E and Series F Excavators {5736}
C7.1 Marine Propulsion Engine Model View Illustrations
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Fan Pump - Test and Adjust
3516B Generator Set Engines with Dynamic Gas Blending Electrical Connectors
C18 Generator Set Engines Piston Cooling Jets - Remove and Install
C7.1 Marine Propulsion Engine Engine Crankcase Breather - Clean
C9.3 Marine Engine Fuel Manifold (Rail) - Remove and Install - Double Wall Rail
C9.3 Marine Engine Fuel Manifold (Rail) - Remove and Install - Single Wall Rail
C9.3 Marine Engine Transmission Oil Cooler - Remove and Install
XQP150 Rental Generator Set Refill Capacities
C18 Generator Set Engines Piston and Connecting Rods - Remove and Install
XQP150 Rental Generator Set Refill Capacities
XQP150 Rental Generator Set Welding on Engines with Electronic Controls
C18 Generator Set Engines Pistons and Connecting Rods - Disassemble
C18 Generator Set Engines Pistons and Connecting Rods - Assemble