Piston Cooling Jets - Remove and Install
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 9S-9082 | Engine Turning Tool | 1 |
Start By:
- Remove the engine oil pump.
Show/hide table
| NOTICE |
|---|
|
Special care must be taken not to bend the piston cooling jets because the piston cooling jets are precision aligned with a coolant passage in the pistons. There is only one position for each cooling jet. The notch in the bottom of the piston allows clearance for the piston cooling jet when the piston is at bottom dead center. |
- Use Tooling (A) to rotate the crankshaft to gain access to the piston cooling jet.
- Remove bolt (1) and piston cooling jet (2).
Show/hide table
| |
| Illustration 1 | g01004705 |
Show/hide table
| NOTICE |
|---|
|
Special care must be taken not to bend the piston cooling jets because the piston cooling jets are precision aligned with a coolant passage in the pistons. There is only one position for each cooling jet. The notch in the bottom of the piston allows clearance for the piston cooling jet when the piston is at bottom dead center. |
- Install piston cooling jet (2) in the reverse order of removal.
- Tighten bolt (1) to a torque of
40 ± 8 N·m (30 ± 6 lb ft)
- Tighten bolt (1) to a torque of
Caterpillar Information System:
3516B Generator Set Engines with Dynamic Gas Blending Electrical Connectors
C9.3 Marine Engine Fuel Manifold - Remove and Install - Single Wall Rail
XQP150 Rental Generator Set Model View Illustrations
Installation and Configuration Procedure for an Autonomous Stop (A-Stop) System {7610, 7620} Installation and Configuration Procedure for an Autonomous Stop (A-Stop) System {7610, 7620}
C15 Generator Sets Maintenance Interval Schedule - Standby Generator Sets
C15 Generator Sets Maintenance Interval Schedule - Prime
C15 Generator Sets Maintenance Interval Schedule - Emergency Standby Power
C18 Generator Set Engines Cylinder Liner - Remove and Install
New Exhaust Gaskets Are Used on Certain 3500 Engines {1059} New Exhaust Gaskets Are Used on Certain 3500 Engines {1059}
C13, C15, and C18 Tier 4 Final Engines Diesel Exhaust Fluid Tank
3512E Petroleum Engines General Information (Fuel System)
Troubleshooting Guide for the Rotary Position Sensor for Cat® Grade Control on Certain Series E and Series F Excavators {5736} Troubleshooting Guide for the Rotary Position Sensor for Cat® Grade Control on Certain Series E and Series F Excavators {5736}
C7.1 Marine Propulsion Engine Engine Crankcase Breather - Clean
C9.3 Marine Engine Fuel Manifold (Rail) - Remove and Install - Double Wall Rail
C9.3 Marine Engine Fuel Manifold (Rail) - Remove and Install - Single Wall Rail
C9.3 Marine Engine Transmission Oil Cooler - Remove and Install
XQP150 Rental Generator Set Refill Capacities
C18 Generator Set Engines Piston and Connecting Rods - Remove and Install
XQP150 Rental Generator Set Refill Capacities
XQP150 Rental Generator Set Welding on Engines with Electronic Controls
C18 Generator Set Engines Pistons and Connecting Rods - Disassemble
C18 Generator Set Engines Pistons and Connecting Rods - Assemble
C18 Generator Set Engines Connecting Rod Bearings - Remove and Install
C18 Generator Set Engines Crankshaft Main Bearings - Remove and Install