Flywheel - Remove and Install
Start By:
- Disconnect the generator.
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Lifting Bracket | 2 |
B | FT2712 | Guide Stud | 2 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install Tooling (A) on the flywheel. Use a suitable lifting device. The weight of the flywheel is approximately
40 kg (88 lb) . - Remove two bolts (1). Install Tooling (B).
- Remove remaining bolts (1) that hold the flywheel to the crankshaft . Remove flywheel (2).
Show/hide table
Illustration 2 g01953204 - If necessary, use a hammer and a punch to remove ring gear (3) from the flywheel.
Show/hide table
Illustration 1 | g01953202 |
- Install flywheel (2) in the reverse order of removal.
- Tighten bolts (1) to a torque of
270 ± 40 N·m (200 ± 30 lb ft) .
Caterpillar Information System:
C18 Generator Set Engines Water Temperature Regulator Housing - Remove and Install
Product Link For Generator Sets Parameters
C18 Generator Set Engines Water Pump - Assemble
C18 Generator Set Engines Water Pump - Disassemble
3516C Generator Set Engines Turbocharger - Install
® Grade & Slope for Cold Planers Grade Control Guidance Screen
C9.3 Marine Auxiliary Engines Maintenance Interval Schedule - Marine Generator Set
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Auxiliary Hydraulic System Troubleshooting
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Visual Inspection (Auxiliary Hydraulic System)
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Machine Preparation for Troubleshooting
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Propel System Troubleshooting
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Visual Inspection (Power Train)
XQP150 Rental Generator Set Product Description
XQP150 Rental Generator Set Plate Locations and Film Locations
XQP150 Rental Generator Set Plate Locations and Film Locations
C18 Generator Set Engines Crankshaft Rear Seal - Remove and Install
G3516B Engines Fuel Metering Valve
C175-20 Locomotive Engine Filter Screen (Air) - Inspect/Clean
3512E Engines Accessory Drive (Front) - Remove and Install
C18 Generator Set Engines Flywheel Housing - Remove and Install
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Conveyor (First Stage) - Test - Case Drain Flow for Piston Motor
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Conveyor (Second Stage) - Test - Case Drain Flow for Piston Motor
XQP1100 Generator Set Cold Weather Operation
C7 and C9 Industrial Engines Air Inlet Heater Circuit - Test