Valve Lifter - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Start By:
- Remove cylinder head.
- Remove valve lifter (2) from cylinder head (1).
Show/hide table
| |
| Illustration 1 | g06041794 |
- Install valve lifter (2) in the reverse order of removal.
- Immerse valve lifter (2) in clean engine oil before assembling in cylinder head (1) lifter bore.
- Install valve lifter (2) in cylinder head (1) with stamped word "LEFT" on end of bronze pin always oriented to the left as viewed from the side of the engine regardless of left or right bank.
Caterpillar Information System:
DG30, DG50, DG60, DG80, DG100, DG125, and DG150 Generator Set Engines Lubrication System
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Relief Valve (Main, Propel Pump) - Test and Adjust
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Diagnostic Trouble Codes
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Sensor Supply - Test
745 and 740 GC & 740 EJECTOR Articulated Truck Systems Pressure Sensor
DG30, DG50, DG60, DG80, DG100, DG125, and DG150 Generator Set Engines Air Inlet and Exhaust System
A New Accessory Drive Bearing Is Used on Certain 3512E Tier 4 Final Engines {1207} A New Accessory Drive Bearing Is Used on Certain 3512E Tier 4 Final Engines {1207}
C12.9 Marine Engines Flywheel - Remove and Install
Aftercooler Leaks on Certain C4.4 Marine Generator Sets {1063} Aftercooler Leaks on Certain C4.4 Marine Generator Sets {1063}
C13, C15, and C18 Tier 4 Final Engines Diesel Exhaust Fluid Tank
C18 Generator Set Engines Engine Oil Cooler - Remove and Install
C18 Generator Set Engines Engine Oil Filter Base - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (First Stage) - Remove and Install
C175-20 Locomotive Engine Model View Illustrations
DG30, DG50, DG60, DG80, DG100, DG125, and DG150 Generator Set Engines Compression - Test
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Relief Valve (Second Stage Conveyor) - Test and Adjust
Supplement for Up-rated 3500 Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Supplement for Up-rated 3500 Engines Crankshaft Wear Sleeves and Seals
Supplement for Up-rated 3500 Engines Engine Oil Filter
DG30, DG50, DG60, DG80, DG100, DG125, and DG150 Generator Set Engines Cylinder Head - Inspect
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Propel Pump Pressure Override - Calibrate
C12.9 Marine Engines Electric Starting Motor - Remove and Install
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Propel Current - Calibrate
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Relief Valve (Auxiliary) - Test and Adjust - Pump