Cooling System Water Temperature Regulator - Replace
在节温器失效之前就更换掉。 此更换是推荐的预防性维护措施。 更换节温器可减少可能发生的计划外停工。
水温调节器在部分开启位置失效时,会引起发动机过热或过冷。
水温调节器在完全关闭位置失效时,会引起发动机严重过热。 发动机严重过热会引起气缸盖开裂或活塞卡缸故障。
水温调节器在开启位置失效时,会引起发动机在部分负荷时工作温度过低。 发动机部分负荷时工作温度过低会造成气缸内过分积碳, 从而加速活塞环和缸套的磨损。
Show/hide table
注意 |
---|
不定期更换水温调节器会引起发动机严重损坏。 Cat 发动机采用分流式旁通设计的冷却系统,需要在安装有水温调节器的情况下操作发动机。 如果水温调节器安装不正确,发动机可能过热,造成气缸盖损坏。 确保新的水温调节器安装在原来的位置。 确保水温调节器的放气孔畅通。 不要在密封垫或缸盖表面上使用液体垫片材料。 |
请参阅拆解和组装, "水温调节器 - 拆卸和安装"。 若需更多资料,请咨询 Cat 代理商。
注: 如果只更换水温调节器,泄放冷却系统中的冷却液时,只需冷却液的液位低于水温调节器壳即可。
Caterpillar Information System:
3516E Generator Set Engines Auxiliary Drive (Lower Left Hand)
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Starting Motor - Inspect
G3508J, G3516J, and G3520J Engines Exhaust Elbow - Remove and Install
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Wiring Harness (Short Circuit) - Test
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Wiring Harness (Open Circuit) - Test
New Generator Set Software Gp Is Now Used on Certain C7.1 Generator Sets {7610, 7620} New Generator Set Software Gp Is Now Used on Certain C7.1 Generator Sets {7610, 7620}
C175-20 Locomotive Engine Event Codes
NEHS1227: 477-3197 C27 Piston Ring Gauge Group {0374, 0599, 0700, 0701, 1214, 1215} NEHS1227: 477-3197 C27 Piston Ring Gauge Group {0374, 0599, 0700, 0701, 1214, 1215}
C1.7 and C2.2 Industrial Engines Gauges and Indicators
C18 Generator Set Engines Turbocharger - Remove and Install
G3508J, G3516J, and G3520J Engines Turbocharger - Install
C1.7 and C2.2 Industrial Engines Fluid Recommendations
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Stator Winding Temperature - Test
Improved ARD Heater Assemblies Are Now Used on Certain C9.3, C13, C15, and C18 Engines {4493} Improved ARD Heater Assemblies Are Now Used on Certain C9.3, C13, C15, and C18 Engines {4493}
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Walk-Around Inspection
C1.7 and C2.2 Industrial Engines General Hazard Information
C1.7 and C2.2 Industrial Engines Burn Prevention
C1.7 and C2.2 Industrial Engines Cooling System Coolant Sample (Level 1) - Obtain
C1.7 and C2.2 Industrial Engines Cooling System Coolant Sample (Level 2) - Obtain
3516E Generator Set Engines Engine Oil Lines
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Prelube Pump - Inspect
Two Piece Stay Rod Installation Instructions for Well Stimulation Pumps {5070} Two Piece Stay Rod Installation Instructions for Well Stimulation Pumps {5070}
New Software is Now Available for all Cat® Object Detection and Vision Applications on Certain Cat® Products {7610, 7620} New Software is Now Available for all Cat® Object Detection and Vision Applications on Certain Cat® Products {7610, 7620}
Pony Rod Seal Installation Instructions {5070} Pony Rod Seal Installation Instructions {5070}