Engine Design
Show/hide table
| |
| Illustration 1 | g00296424 |
|
Cylinder and valve location (A) Exhaust valve (B) Inlet valve | |
Bore ...
Stroke ...
Displacement ...
Cylinder arrangement ... In-line
Type of combustion ... Direct injection
Compression ratio ... 18.0:1
Number of cylinders ... 4
Valves per cylinder ... 2
Valve lash
- Inlet valve ...
0.2 mm (0.0078 inch) - Exhaust valve ...
0.2 mm (0.0078 inch) - Exhaust valve ...
Firing order ... 1, 3, 4, 2
When the crankshaft is viewed from the front of the engine, the crankshaft rotates in the following direction. ... Clockwise
When the camshaft is viewed from the front of the engine, the camshaft rotates in the following direction. ... Clockwise
The front of the engine is opposite the flywheel end of the engine. The left side and the right side of the engine are determined from the flywheel end. Number 1 cylinder is the front cylinder of the engine.
Caterpillar Information System:
C1.7 and C2.2 Industrial Engines Walk-Around Inspection
C1.7 and C2.2 Industrial Engines Turbocharger - Inspect
C1.7 and C2.2 Industrial Engines Monitoring System
An Improved Final Drive Ring Gear Retainer is Now Used on Certain 777 Off-Highway Trucks {4008, 4050} An Improved Final Drive Ring Gear Retainer is Now Used on Certain 777 Off-Highway Trucks {4008, 4050}
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Generator - Dry
C13 Engine and C13 Industrial Engine Gear Group (Rear) - Remove and Install - Flywheel Housing
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Engine Oil and Filter - Change
C2.2 Engines for Caterpillar Built Machines Air in Fuel - Test
C1.7 and C2.2 Industrial Engines Maintenance Interval Schedule
G3508J, G3516J, and G3520J Engines Turbocharger - Remove
C1.7 and C2.2 Industrial Engines Engine Oil and Filter - Change
C1.7 and C2.2 Industrial Engines Engine Crankcase Breather Element - Replace
C1.7 and C2.2 Industrial Engines Welding on Engines with Electronic Controls
C1.7 and C2.2 Industrial Engines Fluid Recommendations
G3508J, G3516J, and G3520J Engines Turbocharger - Install
C18 Generator Set Engines Turbocharger - Remove and Install
C1.7 and C2.2 Industrial Engines Gauges and Indicators
NEHS1227: 477-3197 C27 Piston Ring Gauge Group {0374, 0599, 0700, 0701, 1214, 1215} NEHS1227: 477-3197 C27 Piston Ring Gauge Group {0374, 0599, 0700, 0701, 1214, 1215}
C175-20 Locomotive Engine Event Codes
New Generator Set Software Gp Is Now Used on Certain C7.1 Generator Sets {7610, 7620} New Generator Set Software Gp Is Now Used on Certain C7.1 Generator Sets {7610, 7620}
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Wiring Harness (Open Circuit) - Test
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Wiring Harness (Short Circuit) - Test
G3508J, G3516J, and G3520J Engines Exhaust Elbow - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Starting Motor - Inspect