Gas Admission Valve - Remove
开始:
- 拆下阀室盖。 请参阅拆解和装配, "阀室盖 - 拆卸"。
- 拆下阀室盖底座。 请参阅拆解和装配阀室盖, "底座 - 拆卸"。
- 拆下气门机构。 请参阅拆解和组装, "气门机构 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 卸下推杆 (3)。
- 从进气阀 (2) 上卸下螺栓 (1)。
- 拆下 O 形密封圈。
Show/hide table
图 1 | g03890224 |
Caterpillar Information System:
G3606 and G3608 Engines Rocker Arm - Install
G3606 and G3608 Engines Rocker Arm - Remove
Inspect Inlet Check Valve and Clean Expansion Chamber Before Installing Replacement Air Compressor to Avoid Repeat Compressor Failure{1803, 5502} Inspect Inlet Check Valve and Clean Expansion Chamber Before Installing Replacement Air Compressor to Avoid Repeat Compressor Failure{1803, 5502}
794 AC Off-Highway Truck Machine Systems Control Valve (Hoist) - Assemble
794 AC Off-Highway Truck Machine Systems Control Valve (Hoist) - Disassemble
New Stats and Tube Routings are Now Used for Certain 3512 and 3516 Marine Engines {1355, 1380, 1393} New Stats and Tube Routings are Now Used for Certain 3512 and 3516 Marine Engines {1355, 1380, 1393}
New Software Is Used for Certain 3500 Dynamic Gas Blending Land Electric Engines {1920} New Software Is Used for Certain 3500 Dynamic Gas Blending Land Electric Engines {1920}
2015/09/17 New Software Is Used for Certain 3500 Dynamic Gas Blending Well Service Engines {1250, 1280, 1920}
EMCP 4.4 Supervisory Control Panel Maintenance Interval Schedule
C13 Generator Set Maintenance Interval Schedule - Emergency Standby Power
SRMP Electric Power Generation SRMP Generator Exciter - Remove and Install
C13 Generator Set Maintenance Interval Schedule - Standby
G3606 and G3608 Engines Gas Admission Valve - Install
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
G3612 and G3616 Engines Prechamber Ignition Body - Remove
G3612 and G3616 Engines Cylinder Head - Remove
EMCP 4.4 Supervisory Control Panel Daily Inspection
EMCP4.2B Engine Cooldown Warning
EMCP4.2B Engine Oil Pressure Warning
EMCP4.2B Engine Overcrank Warning
EMCP4.2B Engine Speed Warning
EMCP4.2B Engine Overspeed Warning
EMCP4.2B Engine Underspeed Warning
EMCP4.3/4.4 Generator Control Not in Automatic Warning