Gas Admission Valve - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 更换O 形密封圈。
- 将螺栓 (1) 安装至进气阀 (2)。
- 安装推杆 ( 3)。
Show/hide table
图 1 | g03890224 |
结束:
- 安装气门机构。 请参阅拆解和组装, "气门机构 - 安装"。
- 安装阀室盖底座。 请参阅拆解和装配阀室盖底座, " - 安装"。
- 安装气门室罩盖。 请参阅拆解和装配阀室盖, " - 安装"。
Caterpillar Information System:
G3606 and G3608 Engines Gas Admission Valve - Remove
G3606 and G3608 Engines Rocker Arm - Install
G3606 and G3608 Engines Rocker Arm - Remove
Inspect Inlet Check Valve and Clean Expansion Chamber Before Installing Replacement Air Compressor to Avoid Repeat Compressor Failure{1803, 5502} Inspect Inlet Check Valve and Clean Expansion Chamber Before Installing Replacement Air Compressor to Avoid Repeat Compressor Failure{1803, 5502}
794 AC Off-Highway Truck Machine Systems Control Valve (Hoist) - Assemble
794 AC Off-Highway Truck Machine Systems Control Valve (Hoist) - Disassemble
New Stats and Tube Routings are Now Used for Certain 3512 and 3516 Marine Engines {1355, 1380, 1393} New Stats and Tube Routings are Now Used for Certain 3512 and 3516 Marine Engines {1355, 1380, 1393}
New Software Is Used for Certain 3500 Dynamic Gas Blending Land Electric Engines {1920} New Software Is Used for Certain 3500 Dynamic Gas Blending Land Electric Engines {1920}
2015/09/17 New Software Is Used for Certain 3500 Dynamic Gas Blending Well Service Engines {1250, 1280, 1920}
EMCP 4.4 Supervisory Control Panel Maintenance Interval Schedule
C13 Generator Set Maintenance Interval Schedule - Emergency Standby Power
SRMP Electric Power Generation SRMP Generator Exciter - Remove and Install
G3606 and G3608 Engines Gas Needle Valve - Remove and Install
G3612 and G3616 Engines Prechamber Ignition Body - Remove
G3612 and G3616 Engines Cylinder Head - Remove
EMCP 4.4 Supervisory Control Panel Daily Inspection
EMCP4.2B Engine Cooldown Warning
EMCP4.2B Engine Oil Pressure Warning
EMCP4.2B Engine Overcrank Warning
EMCP4.2B Engine Speed Warning
EMCP4.2B Engine Overspeed Warning
EMCP4.2B Engine Underspeed Warning
EMCP4.3/4.4 Generator Control Not in Automatic Warning
EMCP4.3/4.4 Generator Output Sensing Circuit Fault