Diesel Particulate Filter Temperature Is Low
Use this procedure to troubleshoot the following code:
Show/hide table
Diagnostic Trouble Codes for ARD Failed to Ignite     | ||
J1939 Code     | Code Description     | Comments     |
3242-18     | Aftertreatment #1 DPF Intake Gas Temperature : Low - moderate severity (2)     | The temperature at the intake of the DPF is below the trip point that is calculated by the ECM. The trip point varies depending on engine operating conditions. Active regeneration is disabled.     |
ARD Air Supply
Visually inspect the components for the ARD Air supply. Check for the following faults:
- Confirm that there are no kinks in the air lines to restrict the flow.
- Confirm that the reed valve is not blocked and can move freely.
- Confirm that the air pump belt is tensioned correctly: New belt = 310 N (70 lb), Used belt = 220 N (49.5 lb).
- Check if the air filter is blocked. Change filter if maintenance schedule has passed. Refer to the Operation and Maintenance Manual, "Maintenance Interval Schedule".
- Check the operation of the air pump. Refer to Troubleshooting, "ARD Combustion Air - Test".
ARD Fuel Supply
Visually inspect the components for the ARD Fuel supply. Check for the following faults:
- Confirm if the electric lift pump is damaged.
- Check if the primary fuel filter is blocked. Change filter if maintenance schedule has passed. Refer to the Operation and Maintenance Manual, "Maintenance Interval Schedule".
- Check if the secondary fuel filter is blocked. Change filter if maintenance schedule has passed. Refer to the Operation and Maintenance Manual, "Maintenance Interval Schedule".
- Use electronic service tool to override the ARD injector 2 and check that the ARD injector 2 is injecting fuel.
Battery Voltage
- Confirm that the battery voltage is greater than 13 VDC during a regeneration with all of the engine auxiliary components activated.
Caterpillar Information System:
2014/12/19 New Engine Software Is Available For Certain G3306B Engines {1920}
C15 and C18 Engines Engine Operation
C280 Marine Engines Electronic Service Tool Does Not Communicate
C13, C15, and C18 Tier 4 Final Engines Event Codes
Installing the New Delta Pressure Lines on Certain Tier 4 Interim C9 To C18 Engines {108D} Installing the New Delta Pressure Lines on Certain Tier 4 Interim C9 To C18 Engines {108D}
Inspection of the Fan Drive Pulley and Belts{1357, 1358, 1359} Inspection of the Fan Drive Pulley and Belts{1357, 1358, 1359}
C7.1 Engines Engine Top Speed Is Not Obtained
C7.1 Engines Engine Stalls at Low RPM
C7.1 Engines Engine Shutdown Occurs Intermittently
C4.4 and C6.6 Engines Engine Overcrank Occurrence
C9 Marine Engines Overhaul (Major)
C13 Generator Set Engine Coolant Temperature Sensor - Remove and Install
C1.5 and C2.2 Industrial Engines Diesel Particulate Filter Has Changed Regeneration Interval
2014/12/19 New Software for the Soot Reading Strategy on C7.1 Generator Set {1920}
C7.1 Engines Engine Vibration Is Excessive
C7.1 Engines Exhaust Has Excessive Black Smoke
3512E Land Electric Drive Plate Locations and Film Locations
C7.1 Engines Exhaust Has Excessive White Smoke
C7.1 Engines Exhaust System Contains Oil
3512E Land Electric Drive Engine Oil Level - Check
C280 Marine Engines Turbocharger Turbine Speed Is High
C7.1 Engines Exhaust Temperature Is High
C4.4 and C7.1 Engines Fuel Consumption Is Excessive
3512E Land Electric Drive System Pressure Release